Follett 110FB425A Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Dozownik Follett 110FB425A. Follett 110FB425A 17 stron. Ice and water dispenser

Drukuj stronę

Semi-Annually (more often if conditions dictate)

§ A cleaning procedure should always include both the ice machine and dispenser.

§ Icemaking system can be cleaned in place.

§ Wear rubber gloves and safety goggles (or face shield) when handling SafeCLEAN Plus™ and IMS-III solutions.

§ Use only Follett approved cleaners.

§ It is a violation of Federal law to use the Nu-Calgon

§ Do not use solvents, abrasive cleaners, metal scrapers or sharp objects to clean any part of the dispenser.

Cleaning Tool Checklist

§ (1 or 2) 1.5 gallon (or larger) plastic bucket

§ (2) clean cloths

§ Sanitary gloves

§ Safety glasses

§ (2) SaniSponge™ (P/N 00131524 - single sponge)

§ SafeCLEAN Plus ice machine cleaner

§ [OPTIONAL] Nu-Calgon IMS-III no-rinse sanitizer (P/N 00979674 – 16 fl oz. bottle)

SafeCLEAN Plus Solution: Follow the directions on the SafeCLEAN Plus packaging to mix 1 gal. (3.8 L) of

[OPTIONAL] No-rinse Sanitizing Solution: Follow the directions on the Nu-Calgon IMS-III packaging to mix

Ice Machine and Dispenser

Cleaning Procedure

Note: Check drains and drain cup to ensure they are open and flowing freely.

1. If ice machine was running recently, ensure that the evaporator is completely free of ice before

proceeding. If there is ice in the evaporator, complete steps 2-7 using only hot water to remove the ice,

then begin Cleaning Procedure again.

2. Remove front cover and turn OFF bin signal switch.

3. Dispense all ice from storage hopper and discard.

4. Remove splash panel.

5. Press CLEAN switch. The MAINTENANCE light will turn on and the machine will drain. Wait for the LOW

WATER light to turn on.

6. Remove lid from cleaning cup and fill (about 1 quart) until SafeCLEAN Plus solution completely fills the

reservoir. Place lid back on cup. Save remainder of SafeCLEAN Plus solution.

7. CLEANER FULL light will turn on and machine will start cleaning cycle then rinse three times; this

process takes approximately 15 minutes.

8. While ice machine is cleaning, clean dispenser as follows:

a. Turn OFF dispenser power.

b. Remove hopper lid.

c. Remove knurled nuts from front of storage hopper.

d. Remove stud assembly, baffle, wheel, and any remaining ice.

e. Remove dispense chutes from splash panel.

f. Submerse drain grille in SafeCLEAN Plus solution and allow to soak to remove any scale buildup.

g. Wipe inside of hopper lid, stud assembly, baffle, wheel, inside of storage area, dispense chutes, drain grille

and drain pan with damp cloth wrung out in SafeCLEAN Plus solution. Thoroughly rinse all parts with damp

cloth wrung out with clean water.

Note: To avoid possible damage to motor assembly, only use a damp cloth to clean storage hopper. Do

not allow water to run through motor shaft hole in bottom of hopper.

9. When machine is finished cleaning, the MAINTENANCE light will turn off.

CAUTION!

Follett SafeCLEAN Plus solution. Use 100 F (38 C) water.

1 gal. (3.8 L) of IMS-III solution. Use 100 F (38 C) water.

IMS-III solution in a manner inconsistent with its labeling.

110CT425A/W, 110FB425A/W