Advanced Amplifiers AA-28G-2KW-PT Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Advanced Amplifiers AA-28G-2KW-PT. Advanced Amplifiers AA-28G-2KW-PT 13 stron.
Drukuj stronęOperate time – Time since last time the high voltages were turned on. If in state other than
•
OPERATE it shows the duration the unit was in OPERATE last time.
Main uptime – Time since last time the main control board was powered, meaning essentially
•
the last time the prime power input was connected to AC power.
Temperature screen (Picture 9) shows the temperature of the main control processor, which in general
represents the ambient air temperature inside the unit.
The Pulses screen (Picture 10) shows measurements of the incoming "video" pulses. PpinP stands for
Pulse in Period, PinL for Pulse in Length and PinD for Pulse in Duty [cycle]. When the pulse input is
set to CW, PinP and PinL is undefined while PinD shows 100 %. The values shown correspond to
pulses which will modulate the amplifier's output, when the amplifier is in OPERATE. So the values
represent the output of the internal pulse generator, when it is activated, and video pulse input, when it
is deactivated.
Picture 11: Options screen, System tab
Options screen consists of 4 tabs. Contact tab (picture 12) shows the contact information of the
amplifier's manufacturer. System tab (picture 11) shows general information about the amplifier and
selected technical data.
The following information is available: Model, Series, Rated power output, Min. and max. supported
frequency and serial number, ADC sampling rate for main control and RF control.
Picture 10: Pulses screen
Page 8 of 13
Picture 12: Contact screen