Daihatsu EDM30ZII Instrukcja obsługi - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System otwierania drzwi Daihatsu EDM30ZII. Daihatsu EDM30ZII 16 stron. Microprocessor-controlled door operator
4.
Pressing
the test button
indicator (red)
5.
Brake
force
adj ustrnent
the low-speed
zone is set to 50-l00rnrn.
excessively weak, the door hits the door frame at
high speed, or, when the door stops moving in the reverse
direction, it goes beyond the proper stopping point. If the
braking is excessively strong, the door judders to stop ..
If the cushion mode is set to Auto (factory-setting),
speed zone is automatically adjusted to 50 _60 mID regardless of
the slow-speed
6,
7.
High-speed
adjusters
for closing speed)
(\
For proper adjustment, start with a low
gradually
increase
slow-speed
zone is at least 50mm. The
closing
speed must be slower than the
opening
speed,
8.
Cushioning
speed
This adjusts the door speed
the cushioning mode is "Fixed". Normally adjust to 50 -60
mm/sec. An excessively slow set ting
operation. See the slow speed section in the teaching
process.
9.
Open timer
This adjusts
the door-open
the sensor turns OFF to when the door
actually
starts to close. The adjustment
range is between
set it to 1 -2 seconds.
lights the sensor
Adjust the brake force so that
If
braking
zone setting.
(6:
for
opening speed, 7:
speed,
the setting
so that the
for the safety
reasons.
(low-speed)
adjuster
after
a brake is applied. Use if
results in poor door
time, from when
0.5 and 10 seconds.
is
the slow
then
Povver supply
Green: 100V Min.Max. S
ned: Alarm
• Aft!!r adjusting any
menl
knobs. always
then ON to check the !!Hl!cl.
I
Normally
100
50-70
Braking
Cushion
Closing
@-~-
F
5
Speed
0'
the speed adjusl-
lurn the povver OFF
I
r
•
(~
.
.~~
1.00
I
Opening
F S
F
...,