DPCAV ShutterBug Pro Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler DPCAV ShutterBug Pro. DPCAV ShutterBug Pro 16 stron. Digital camera controller

The photo on the right shows how the two camera

stages are identified on ShutterBug Pro's circuit board.

The connections must be made by soldering your

custom made wiring cable to the indicated pads. Use a

temperature controlled soldering iron set for delicate

soldering work.

The Stage-1 and Stage-2 switches are polarity

sensitive. So, they must be wired to match the polarity

of your camera. This can be determined by using a voltmeter across the camera's shutter

button (switch) contacts during its resting state.

Direct Connect Method:

Not all cameras do a focus when the shutter

button is depressed. Or perhaps you do not

want to use the cameras auto focus feature. If

so, only two wires are needed.

Not Used

N/A

Shutter Positive

SHUT+

Shutter Negative

SHUT-

Direct Connect Method:

Typical wiring for a camera that has an auto

focus stage is accommodated with the 4-wire

scheme.

Focus Positive

FOC+

Focus Negative

FOC-

SHUT+

Shutter Positive

Shutter Negative

SHUT-

2-Wire

4-Wire

Page 4

Figure 7, Basic Direct Connect ID

Figure 8, 2-Wire Layout

Figure 9, 4-wire Layout

Sep-15-2013