Amprobe CT-400 Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Czujniki bezpieczeństwa Amprobe CT-400. Amprobe CT-400 10 stron. At-6000 series. advanced wire tracer
Drukuj stronę
AT-6000 Advanced Wire Tracer Series - Quick Guide
Identifying Breakers and Fuses
1
Set-up:
Test Leads
AT-6000-T
TRANSMITTER
HI
LO
Proper connection
with separate
ground
Separate ground connection (Preferred)
AT-6000-T
TRANSMITTER
HI
LO
Simplified direct connection
1. Connect the green and red test leads to the
Transmitter using either simplified direct
connection or separate ground connection.
Separate ground connection (preferred): first
connect the red lead to the Energized hot wire on
the load side of the system. The signal will ONLY
be transmitted between the outlet to which the
Transmitter is connected and the source of power.
Simplified direct connection: connect the test
leads directly to the hot and neutral wires. While
locating a breaker, wires will not be traceable as
the signals will cancel each other out.
2. Connect the green lead to a separate ground.
2
2
Set-up:
Transmitter
Blinking
Transmitter indicator
showing signal in
HIGH mode
1. Turn on the Transmitter.
2. Verify that the test leads are properly connected;
the red LED voltage status light should be on
for circuits with voltage above 30 V AC/DC, and
it should be off for De-energized circuits below
30 V AC/DC.
3. Select HIGH signal mode by pressing HI. LED
display will quickly begin to blink.
Receiver:
Breaker Tracing
Align the tip sensor
groove with the breaker
1. Turn on the Receiver and continue pressing the
MODE button until Breaker Locating mode is
selected.
2. Align the groove on the Tip Sensor with the
breaker lengthwise.
3. Scan all breakers in any order. Breakers can be
scanned multiple times. It records the highest
signal level and will automatically adjust sensitivity.
The Receiver may beep and the green arrow may
light up several times during this step.
4. Locate the breaker by scanning all breakers again;
the Receiver should indicate only one breaker.
AT-6000-T
TRANSMITTER
HI
LO