Amprobe CT-400 Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla GPS Amprobe CT-400. Amprobe CT-400 10 stron. At-6000 series. advanced wire tracer
AT-6000 Advanced Wire Tracer Series - Quick Guide
Special Application: Finding Shorts
1
Set-up:
Transmitter
Verify the Loop
LED is ON.
1. Connect the Transmitter with the test leads
to the circuit.
2. Hold down the HIGH button for two seconds
to activate Loop mode.
Wire tracing mode:
Tracing a cable to find shorts
1. Start tracing the cable until the signal stops.
2. Verify the place of the fault: move the
Transmitter to the other end of the wire and
repeat tracing from the opposite end. If the
signal stops at the exact same location the
fault has been located.
4
AT-6000-T
TRANSMITTER
HI
LO
AT-6000-T
TRANSMITTER
HI
LO
2
Set-up:
Receiver
Precision
tracing mode
1. Turn on the Receiver
2. Press the MODE button to select a
wire tracing mode (either Quick Scan or
Precision Tracing).
Note:
This method will be affected
by signal cancellation effect. Expect
a relatively weak signal.
88
NCV