Carcam G-800 Instrukcja instalacji i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Kamery samochodowe Carcam G-800. Carcam G-800 13 stron.
Drukuj stronęCMOS
Lens
LCD
Photo Format
Picture resolution
Video resolution
Storage
Video format
CPU
Fill-in light
Notes：
1. Use the back straps in accessories to fix the camera to the original car's rear-view
mirror. Depending on the size of the original car mirror, you may have to offset the mirror
slightly. (NOTE: once installed, check the clearance to the sun visors? In a small number of
installations, because the mirror is wider than the original in may snag the sun visor when
it's being lowered. Check this now, so you're aware if the mirror needs to be adjusted when
lowering this visor)
2. Connect the car charger to the 12V socket (cigarette lighter), to charge the car camera
(The device only supports charging by USB5V). The car charger has a supplementary USB
socket built into it so you can plug another device in while it's in use.
3. As long as the car camera is connected to the 12V socket switching on the ignition will
power up the camera and it will start recording automatically. When the ignition is
switched off, the car camera will stop recording and save the recorded data.
4. To use the rear camera it only needs to be plugged in to begin recording. Ideally, the rear
camera should be installed at the top and in the centre of the rear window.
5. Please note the device should be connected to the car charger or DC power when in use
as it requires reasonable power. When disconnected, the internal battery can only power
the unit for a short time. Please also use the original car charger to charge the car camera.
3．Specification
1.2M CMOS Sensor,
1/4 inch Light-sensing
Surface Area
Dual lens, 170 degree
ultra-wide angle lens.
4.3inch high definition
LCD screen
JPG
8.0MP
Front Camera 2.0MP
1920*1080P（FHD）
Back Camera 1.0MP
720*480P
SDHC, Support up to
32G TF Card
H.264 Compression
Code,MP4 Play format
4 core
LED
4．Installation instructions
Motion
Built-in Sensitive Motion
detection
Detection
Three-dimensional
Gravity
Vibration Sensor, Save the
sensor
Recording Video
Built-in
Audio
Microphone/Speaker(AAC)
Seamless continuous
recording. New file
Cycle
automatically covers oldest
recording
file when SD card is full.
Locked files can't be over-
written.
Language
Multi language
Built-in lithium ion polymer
Battery
battery
DDR
1G DDR3
Operating
-20℃ TO 70℃
temperature
Aperture
2.0