Ampt ANALOGER ADG-1 Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Pedał muzyczny Ampt ANALOGER ADG-1. Ampt ANALOGER ADG-1 20 stron. 100% analog bucket brigade delay
Drukuj stronę
MIX MODULE
The Level module provides level matching, wet/dry blending, and tonal
control of the ADG-1.
DRIVE: The DRIVE knob
provides up to +23dB of drive
and level matching as well as
some attenuation for hot input
signals. Unity gain is at about
9:00 but try cranking it for
some soft clipping and limiting
or to drive the BBDs hard. The drive affects both the wet and dry signals
and each have separate limiters with a different knee and threshold.
MIX: The MIX knob is designed to give you a cross-faded wet/dry mix
between the delayed and clean tone. In order to make it easier to adjust this
knob does not go 100% wet or 100% dry but very close. It gets to almost
100% wet with only a slight "ghost" dry signal but it does not approach as
close to fully dry so you will still hear a slight delay sound in the mix. This
is to make the knob easier to adjust and dial in an exact mix.
Note: If you're applying a sustained steady pitch to the ADG-1 and have the MIX knob set near
12:00, you may find that the direct and delayed signals alternately reinforce and cancel each
other in rapid succession as the DELAY TIME is varied. This is a normal result of mixing a
steady pitch with a delayed replica of itself. It is the analog delay equivalent of "standing
waves" in a reverberant room.
TONE: The TONE knob is Hawker's new touch for delays. It is a
modified "tilt type" filter with a soft curve that provides both high pass and
low pass control with a knee around 600Hz. It is placed INSIDE the
feedback loop so may be used to make each repeat sound progressively
more different with each repeat. You can use it in Low Pass mode to make
the sound fold under your playing or in high pass mode to make each
repeat punch and stand out more with a bright metallic sound.
<9>