AMS TMD2635 Skrócona instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Jednostka sterująca AMS TMD2635. AMS TMD2635 10 stron. Miniature proximity sensor module
Również dla AMS TMD2635: Skrócona instrukcja obsługi (8 strony)

Drukuj stronę

Connect Hardware

Plug the TMD2635 daughterboard into the controller board (Figure 1). Always use ESD procedures

when handling the EVM.

Using the enclosed USB cable, plug the micro-B connector into the EVM module. Using the other end

of the cable, plug the USB A-connector into a USB port on the computer.

When the USB cable is connected, the green LED should light on power up to indicate that power is

being received via the USB interface, and the controller board processor is running. If the green LED

does not light, check the USB cable connections; unplug the USB cable and try again. If the green

LED still does not light, check the PC for USB error messages. When the software application is run, it

will turn off the LED.

Quick Start Guide • PUBLIC

QG000142 • v2-00 • 2022-May-19

Document Feedback

TMD2635 ● TMD2635 EVM

Connect Hardware

│ 7