Advanced Bionics Roger Select Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Mikrofon Advanced Bionics Roger Select. Advanced Bionics Roger Select 2 stron.

Drukuj stronę
DEVICE DESCRPITION
Roger Select is a microphone that picks up the voice of a speaker and sends it wirelessly directly into your
hearing devices. You can place Roger Select in the middle of a table e.g. in a restaurants, or it can be
worn by a single person i.e. to hear a distant talker. Follow the steps below to pair the Roger Select.
PAIRING ROGER SELECT TO A
PROCESSOR OR HEARING AID
1
Turn on the Roger Select. Ensure the
appropriate battery to the Roger receiver is
attached to the processor or hearing aid.
2
Hold Roger Select within 10 cm/4 inches from
the Roger receiver or hearing aid.
3
Press the "Connect" button
of the Roger Select.
TIP
The back indicator light will turn green for two
seconds to confirm a successful connection.
You can connect an unlimited number of Roger
receivers to your Roger Select, simply repeat
step 2 and 3 for any other Roger receiver.
Connect
Blue Blinking
Solid Green
Red Double
Blinking
Red Triple
Long Blinking
STANDBY MODE
To enter standby mode, briefly press the
1
on/off button to put Roger Select into
Bluetooth standby mode. This means the
Roger Select microphone is switched off but
incoming calls can still be received.
In Bluetooth standby mode, the battery of the
2
Roger Select is drained. It is recommended
to switch off the Roger Select completely if
no calls are expected to be made.
on the back
Connecting or
pairing mode
Connecting/pairing
successful
Connect timeout,
move device closer
Device not
compatible
ROGER™ SELECT
PAIR ROGER SELECT WITH YOUR
PHONE / COMPUTER (BLUETOOTH)
Turn on the Roger Select and phone/computer.
1
Place next to each other.
Ensure the phone/computer Bluetooth setting is
2
enabled.
On the phone/computer, choose SEARCH or
3
SCAN to search for Bluetooth enabled devices or
audio enhancements.
Press the Bluetooth button
4
the blue light fades and then push it again briefly
until it blinks blue.
The phone/computer should present a list of
5
Bluetooth devices it has detected. Scroll down to
choose "Roger Select" from this list and confirm
the connection is established.
The Roger Select should now be paired to the
6
phone/computer and the indicator light will stop
blinking.
To add another Bluetooth device, briefly press
7
until the back indicator light blinks blue again
and repeat steps 2 to 6.
TIP
The phone/computer may ask to enter a
passcode. If so, enter '0000'. Some
phones/computers may ask which Bluetooth
service you want to enable, select Headset audio
device and microphones in parallel.
Bluetooth
Blue Slow
Blinking
Blue Double
Blinking
Blue Solid
Blue Fast
Blinking
QUICK GUIDE
for 2 seconds until
Bluetooth Standby
Mode
Incoming Call
Active Call
Network Issue,
please press the
connect button