Electrolux 241567601 Instrukcja obsługi i konserwacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Lodówka Electrolux 241567601. Electrolux 241567601 21 stron. Top mount refrigerator

Drukuj stronę

Top Hinge

Cover

1. Disconnect electrical supply.

2. Remove toe grille (see page 4 to learn how).

Top Hinge

To remove freezer door:

1. Remove top hinge cover and screws.

2. Trace around the hinge with a soft lead pencil. This makes reinstallation easier.

3. Remove top hinge and lift door off bottom hinge pin.

4. Reverse this procedure to reinstall freezer door.

To remove refrigerator door:

Cable

1. Place wood block under door to support its weight.

2. Unfasten the multi-wire cable bracket by removing its screw from the cabinet.

3. Detach the multi-wire cable connector located below the door.

Bottom

Hinge

Water

Tube

Cable Bracket

Wood Block

4. Detach the water tube from the connector located below the door. The connector

Shim

Center

5. Remove the bottom hinge screws and hinge, holding the door as its weight rests

Hinge

6. Remove the center hinge screws and hinge. Ensure plastic washer stays on

7. Reverse this procedure to reinstall refrigerator door. When both doors are

Door Removal Instructions

DOOR REMOVAL INSTRUCTIONS:

If your refrigerator will not fit through an entrance area, you can reduce its size by

removing the doors. Check first by measuring the entrance.

IMPORTANT: Before you begin, turn the refrigerator temperature control to "0" and

remove the electrical power cord from the wall outlet. Remove food from door shelves.

Place your thumbs on flat sides of each connector, grasp firmly, and bend both

ends back and forth while pulling apart.

NOTE: You may need to insert a flat screwdriver between the connector ends to

release the locking tab (see illustration).

releases when you press its outer sleeve inward.

NOTE: If refrigerator has been used, have a container ready to catch excess water

from tube.

on the wood block. Lay the door on its side to avoid damage to cable and tube.

hinge pin.

reinstalled, connect water line by inserting tube and pushing until mark touches

face of fitting. Connect cable, replace toe grille, and plug in electrical power cord.