Electrolux Built-In Dishwasher Instrukcja instalacji - Strona 21

Custom Panel Instructions

Items you will need:

Custom Panel Door Front (max weight: 16 lbs)

Panel MUST be ¾ inch thick.

Tape Measure

Electric Drill

Torx (T-20) Head Screwdriver

1/8" Drill Bit

5/32" Drill Bit

Masking Tape

Safety Glasses

Original Installation Instructions

Additional items required if using handle provided with dishwasher:

#10 – 32 Bolt, 1" Long

7/32" Drill Bit

ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING SHOULD BE DONE IN

ACCORDANCE WITH NATIONAL AND LOCAL CODES BY QUALIFIED INDIVIDUALS

CHECK LOCAL PLUMBING CODES

FOR APPROVED PLUMBING

PROCEDURES AND ACCESSORIES.

This appliance must be connected to a

grounded metal, permanent wiring system;

or an equipment-grounded conductor must

be run with the circuit conductors and con-

nected to the equipment-grounding terminal

or lead on the appliance.

This dishwasher is designed for operation on

an individual 120 VAC, 60 Hz grounded

electrical circuit. Use required fuse (15 amp)

or comparable circuit breaker. Two wire

with ground service to the dishwasher is

recommended for connection at the

terminal box and for grounding.

Part No.

6 919950 B