Electrolux CARAVAN AES II RM 6505 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Lodówka Electrolux CARAVAN AES II RM 6505. Electrolux CARAVAN AES II RM 6505 11 stron.
Drukuj stronę
IF THE REFRIGERATOR FAILS TO WORK
Check the following points before calling a service tech-
nician:
1.
that the green AES LED goes on, when the switch
(A) is set to "ON" (12 V must be available).
2.
when mains are connected but the refrigerator stays
in gas operation: Is the refrigerator correctly connec-
ted and is the fuse (230-240 V) intact?.
3.
is the 12 V fuse intact?
4.
Disconnect the wall plug, and the 12 V wires
before servicing. Check the fuses on the circuit
board, (under the black cover at the top of the refrig-
erator and behind the control panel).
Remove the two screws holding the control panel,
pull out the control panel with its electronics. Remove
the cover and check the fuses.
5.
if the refrigerator does not operate in DC mode when
the engine is running:
Is the alternator (D+) connection made correctly?
6.
if the AES LED (C) flashes red: see chapter Gas
trouble-shooting.
If the refrigerator is not cold enough it may be
because:
1.
The ventilation is inadequate owing to reduced area
of the ventilation passages (partial blockage of grilles
from wire mesh etc.).
2.
The evaporator is frosted up.
3.
The temperature control setting is incorrect.
4.
The gas pressure is incorrect - check the pressure
regulator at the gas container.
5.
The ambient temperature is too high.
6.
Too much food is loaded at one time.
7.
The door is not properly closed or the magnetic
sealing strip is defective.
If the refrigerator still does not work properly, call a
service technician.
WARNING! The sealed cooling system must not
be opened, since it contains corroding chemi-
cals under high pressure.
MAINTENANCE
Always turn to a qualified service technician who is
familiar with LP gas systems and refrigerator.
We recommend that a service technician check the
refrigerator once a year.
•
Check that the gas safety shut-off valve is working
properly.
•
The ventilation openings are unobstructed.
•
The Instruction Manual is available.
•
Check all connections in the LP gas system for gas
leaks. Connections can be tested for leaks using a
soap solution. Do not use a naked flame! If there is
any suspicion of damage, call for a service technician.
•
Check that the burner is clean and free from combus-
tible material.
SOME USEFUL HINTS
Make sure that:
•
Defrosting is carried out periodically
•
The refrigerator is clean and dry with the door left
open when it is not to be used for some time.
•
Liquids or items with a strong odour are well packed.
•
The ventilation openings are unobstructed.
•
The doors are secured by means of the both travel
catches when the caravan is on the move.
SERVICE AND SPARE PARTS
Service and spare parts are obtainable from your dealer
or Electrolux - consult the telephone directory.
INSTALLATION INSTRUCTIONS
REPOSITIONING THE HINGES
The refrigerator is equipped with reversible doors.
A special door reversing kit must be used to reverse the
doors.
For further information, contact your dealer or Electrolux.
DOOR PANEL
Door panels can easily be fitted or changed. The dimen-
sions of the panels must be:
Model
Height
upper door
lower door
Width
Thickness max.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
table and the instructions are read thoroughly.
When mounting the panel, proceed as follows:
Upper door
•
remove the two screws holding the control panel
•
unscrew the upper hinge pin and remove the door
•
unscrew the upper part of the door frame, remove the
old panel
•
insert the new panel and push the panel downwards
•
fasten the upper part of the door frame with its three
screws
•
please note that the panel must be changed on the
lower door, before the upper door can be mounted
Lower door
•
unscrew the middle hinge pin and remove the door
•
unscrew the lower part of the door frame, remove the
panel stop (2x) and remove the old panel
•
insert the new panel and push the panel upwards, put
the panel stop back in place and fasten the lower part
of the door frame with its three screws
•
replace the lower door
RM 6505
265 ±1mm
833 ±1mm
483 ±1mm
4
mm
15