Bosch SB Series Instrukcja obsługi - Strona 38

Drukuj stronę

Installation and connection

The connection may be modified by

technicians only.

A power cord extension may be

purchased from customer service

only.

Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply

is connected.

Removing the appliance

Also observe

the sequence of worksteps here.

1. Disconnect the appliance from

the power supply.

2. Turn off the water supply.

3. Undo the waste water and drinking

water connection.

4. Loosen fastening screws for

the furniture parts.

5. If fitted, remove the base panel.

6. Pull out the appliance, carefully

pulling the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according to the

following steps:

1. Turn on the tap.

2. Close the door.

3. Switch on ON/OFF switch (.

4. Select programme with the highest

temperature.

The expected programme duration is

indicated on the numerical display

)".

5. Press START button P.

Programme sequence starts.

6. After approx. 4 minutes press the

START button P until :

indicated on the digital display.

After approx. 1 min :

on the digital display .

7. Switch off ON/OFF switch (.

8. Turn off the tap, disconnect supply

hose and drain water.

Transport appliance upright only.

(This prevents residual water from

running into the machine control and

damaging the programme sequence.)

Protection against frost

If the appliance is in a room where there

is a risk of frost (e.g. holiday home),

empty the appliance completely (see

Transportation).

is indicated

P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e )