Dragonfly DF-TB-XXX-ALR Series Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ekran projekcyjny Dragonfly DF-TB-XXX-ALR Series. Dragonfly DF-TB-XXX-ALR Series 4 stron. Ambient light reflecting thin-bezel fixed projection screens

Fixed Projection Screen Manual
Step 1. Unpack the Screen
Lay out all parts on a clean, flat surface. To prevent damage, do not unpack the screen material at this time.
NOTE: Quantities below may be greater than needed for assembly.
Package Contents
Screen Frame & Frame Bezels
(2 short, 2 long each)
Plastic Protective
Sheet (1)
Sliding Nuts [installed]
(16)
Gloves (2 Pair)
Step 2. Prepare Frame Sections for Assembly
A. Retention springs are pre-assembled. Please confirm
based on quantity noted on frame label for the short
and long frame sections.
i.
The hook on the spring must be nearest the
inside frame edge.
B. Sliding nuts are pre-installed into frames, 16 total.
Sliding nuts are used to install the thin bezel caps,
center stabilizing bar, and wall brackets. Please
ensure all 16 sliding nuts are on the frames prior to
installing and tightening the corner brackets.
C. Install the corner brackets to the top and bottom
slots of the short frame sections.
i.
The small bracket goes in the bottom slot, and
the large one goes in the top slot.
Step 3. Assemble the Frame
A. Slide the short frame sections into the long frame
sections.
B. Insert the 8 frame corner screws into all 4 corners
of the frame and loosely tighten to hold the frame
together.
C. Hand-tighten all four screws, ensure the corners are square, then tighten the screws completely.
D. Lift up and set aside to prepare screen material for assembly.
© 2018 Dragonfly
Corner Brackets
(5 small, 5 Large)
Spring Tool (2)
Material Springs
[installed]
Mounting Bracket (3)
Magnets (3)
2
Center Stabilizing
Bar (1)
M5x40mm Phillips
Head Screws (6)
Thin Bezel Frame
Brackets (12)
M5x8mm Mounting
Screws (3)
x32
B
Screen
Material (1)
Concrete
Anchors (6)
M5x6mm Corner
Screws (56)
Micro Fiber Cloth (1)
C
180822-0935