Dragonfly DFRM Instrukcja instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ekran projekcyjny Dragonfly DFRM. Dragonfly DFRM 9 stron. Recessed in-ceiling motorized projection screen

Drukuj stronę

Step 10. Install the Trim Pieces

Install the end caps after the screen has been installed and leveled.

Step 11. Install the Fixed Panel

Begin with the screen completely retracted so that the hinged door is closed.

2. Ensure that the rubber stops on the magnetic brackets in the housing are resting against the

hinged door when closed for proper alignment of both doors.

3. Lower the screen enough for the hinged door to open and fall out of the way.

4. Install the fixed panel by hooking the edge into the front of the housing, then pushing the panel

up until the magnets attach it to the brackets.

5. After installing the panel, retract the screen to the closed position and adjust as needed for a

flush appearance.

Step 12. Adjusting the Tab Tension Setting

(TAB Models Only)

If the sides of the screen appear wavy or bent, the tab tension setting

must be adjusted. Turn the adjustment knob on each side until both

sides are even and flat.

To tighten the tabs, turn the adjustment knob clockwise.

To loosen the tabs, turn the adjustment knob counterclockwise.

Cleaning the Screen

Follow these guidelines to clean any marks or residue from the viewing surface:

• Do not clean the screen case with water.

• Use a dry microfiber cloth to clean dust and dirt from the housing and screen on regular

occasions.

Troubleshooting

Dragonfly screens are designed to function trouble-free for years of enjoyment. Most issues are

simple and easy to resolve. If you have trouble, review the installation instructions. Resolutions to

common issues are listed in the table below.

Issue

Solution

If the screen is repeatedly reversed while in motion, it may stop moving

and reacting to any control method. This is a safety feature that keeps the

motor from overheating. If this occurs, stop testing for about five minutes,

then resume.

The screen is not

Check the film screen's power connection. Use a voltmeter to check for

reacting to any form

power and that polarity is correct.

of control.

Disconnect all control cables and use the manual control switch on the

bottom left side of the screen housing. If this works, check the desired

control method for problems, such as the wiring and control codes being

used. If needed, consult the controller manufacturer to confirm that all the

settings are correct. If this doesn't work, check power as indicated above.

The viewing surface

See "Step 9. Adjust Screen Travel" on page 11.

is too high/low.

Change the batteries in the RF remote. (2x AAA alkaline)

RF control does

not work but other

The remote may not be paired to the screen. See "Step 7. Pair the RF

control methods do.

Remote" on page 9.