DragonSaw DRS24H10 Instrukcja bezpieczeństwa i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja bezpieczeństwa i obsługi dla Piła DragonSaw DRS24H10. DragonSaw DRS24H10 10 stron.
Drukuj stronę
Operation
The saw is design to safely cut only concrete, masonry and stone.
Visually inspect the saw for any defect parts before using. NEVER operate a defective saw or
blade.
If damages or defects are notice have the saw repaired by a trained and experienced
personnel before using.
Keep the saw clean, free from any accumulated debris, slurry, oil, grease, or any other
substances that would impair to safely operate the saw.
Only a trained person who has read and understand the operating instruction, has experience
with the use and operation of saws, the related usage of the tool and completely understand
the instruction manual in conjuncture with his experience and knowledge in the safe
operation of saws should operate the saw.
NEVER exceed the manufacturer recommended pressure rating and gallons per minutes
(GPM) specification or the electric power requirements of the motor. NEVER exceed the
manufacturer recommended operating speed.
Make certain that the saw is in the neutral position before starting the hydraulic power
supply and that the previous instruction on the visual inspection of the tool has been carried
out.
Remove any material, debris, water accumulation, slurry or any other foreign objects from
the work area that could prevent you to safely operate the tool.
The cutting operation may produce sparks when embedded steel is encounter in the concrete
being cut. No flammable material or fluid should be in your work area. DO NOT operate the
saw in confine space or an area where a spark could produce an explosion.
Always be alert and vigilant.
DO NOT use the saw or the tool other than its intended application.
Cut in step not to overload the tool to prevent overheating, damage to the motor or to put to
much stress on the blade.
DO NOT apply to much pressure to the tool and maintain a firm grip at all time.
Disconnect all power and water supply at the completion of your work.
DO NOT leave an un-attendant tool hook to the power supply.
Clean the tool completely.