Electrolux WRT8G3EWB Instrukcja obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Lodówka Electrolux WRT8G3EWB. Electrolux WRT8G3EWB 18 stron. Top mount refrigerator

Drukuj stronę
TO REMOVE REFRIGERATOR HANDLE:
(Handles may be easier to reverse while doors are off.)
Figure
! Style
Handles
1.
Remove two screws attaching handle to top of refrigerator
door,
2.
Remove screw attaching bottom of handle to door.
3.
Remove two hole plugs and hinge pin plug on top of door
and install on opposite side. Use Phillips head screwdriver
to remove plastic screw plug from front of door and install
on opposite side
Figure
2 Style
Handles
1,
Remove two screws attaching handle to top of refrigerator
door.
2.
Swing top of handle away from door and slide handle
down and off of dovetail button.
3.
Remove screw and dovetail button and install on other
side, moving hole plugs from corresponding
holes to
opposite side.
TO ATTACH REFRIGERATOR
HANDLE:
Figure
1 Style
Handles
1.
Secure bottom of handle with screws.
2.
Secure top of handle with screws.
Figure
2 Style
Handles
1.
Start with handle offset away from door. Place bottom of
handle over dovetail button, swing handle into an upright
position and pull upward, locking it into place.
2.
Secure top of handle with screws.
TO REMOVE REFRIGERATOR HANDLE:
(Handles may be easier to
reverse while doors are off.)
1.
Remove two screws
attaching handle to top of
refrigerator door.
2.
Remove button plug
using edge of putty knife.
3.
Remove screw on side of
refrigerator door and
remove handle.
4.
Reverse freezer and
refrigerator
handles as
shown in figure 3.
Figure 3 - Handle Reversal
TO ATTACH
REFRIGERATOR
HANDLE:
1.
Secure side of handle to
door and replace plug
button.
2.
Secure handle to top of
door.
Refrigerator Door Without Trim
TO ATTACH TRIM:
1.
Slide both trim locks out of trim.
2.
Insert new adhesive trim rocks contained [n your literature
pack.
3.
Install trim to handle by sliding under base of handle.
Carefully align trim and press down at trim lock locations.
4.
Use rubbing alcohol to remove any adhesive residue from
old trim lock locations.
Lock Handle
ov6r
Dovetail
uttoe
Adhesive
Lock
"r_im
Lock
Figure 1
Figure 2
REMOVING STAINLESS STEEL DOORS AND HANDLES
To Remove Doors
Stainless steel doors are not reversible. Follow these steps to
remove doors.
Shoulder
1.
Remove toe grille and
top hinge cover.
2.
Remove top hinge and
lift freezer door off of
center hinge pin. Set
door aside.
3.
Unscrew center hinge
pin using adiustable
Shoulder
wrench and save for
Screw
Screw
reassembly. Ensure
Typical Handle
plastic washer stays on
hinge pin.
4.
Lift refrigerator door off of bottom hinge and set aside.
5.
Remove center hinge and shim by removing inside
screw and loosening two outside screws enough to allow
hinge to slide out. (continued on next page)