Dragster DAF 3001 Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wzmacniacz Dragster DAF 3001. Dragster DAF 3001 17 stron. Power amplifiers
Również dla Dragster DAF 3001: Instrukcja instalacji i obsługi (18 strony)
Drukuj stronę
DAF 3001 / DAF 5001 / DAF 7001
#9
Use heavy gauge wire to connect both amplifiers speaker negative (-) connection.
When bridging two DAF mono amplifiers, the final impedance of the bridged channel
shall be not less trhan 2-ohm.
Under no circumstances can you bridge different models of amplifiers.
RCA HEAD UNIt SIgNAL tO MAStER AMP ONLy!
NO RCA CAbLES tO bE AttACHED tO SLAVE AMP
20
BRIDGING TWO MONO CHANNEL AMPLIFIERS
PoSItIve teRMInAl OF WOOFER tO
MAStER AMPLIFIER POSItIVE tERMINAL
2-OHM FINAL IMPEDANCE LOAD
MInUS teRMInAl OF WOOFER tO
SLAVE AMPLIFIER POSItIVE tERMINAL
MAStER AMP IN MAStER MODE
RCA CABle: fully adjusted signal
SLAVE AMP IN SLAVE MODE
is transferred from Master to Slave amp
DAF 12KW
BRIDGING TWO MONO CHANNEL AMPLIFIERS
RCA HEAD UNIt SIgNAL
tO MAStER AMP ONLy!
DAF 12KW - SLAVE AMPLIFIER
SLAVE AMP IN SLAVE MODE
CAUTION!
DAF 12 KW. AMPlIFIeR'S SInGle UnIt MInIMUM IMPeDAnCe IS 1 ohM.
lInKeD MInIMUM IMPeDAnCe IS 2 ohM.
DAF 12KW - MASTER AMPLIFIER
MAStER AMP IN MAStER MODE
PoSItIve teRMInAl
OF WOOFER
tO MAStER AMPLIFIER
POSItIVE tERMINAL
2
8 OHMS
˜
MInUS teRMInAl
OF WOOFER
tO SLAVE AMPLIFIER
POSItIVE tERMINAL
WoRKInG voltAGe IS 9v
16v
˜
21