Dragster DDM5000.1 Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wzmacniacz Dragster DDM5000.1. Dragster DDM5000.1 8 stron.

Drukuj stronę

SPEAKER (OUTPUT): This output is MONO. Be careful of maintaining the correct polarity of the

connections between the speakers and check the minimum impedance of this output. Use cables with

minimum gauge as specified for the purchased model.

VENTS: Allows for the removal of warm air from the amplifier. In model DDM5000.1, this opening has a fan.

POSITIVE POWER SUPPLY

It is extremely important that a protective fuse or circuit breaker be used on this cable at a distance of

30 cm from the battery. The fuse or circuit breaker should be, at minimum, equal to the max current

consumption value caused by playing musical signals (see technical specifications table).

REM (REMOTE CONTROL): Connect the REM terminal to the electric antenna output of the receiver or

player. This will cause the amplifier to turn on automatically when you turn on your receiver or player.

GROUND CONNECTION

wire

of the player or other equipment to the same ground point.

CLIP LED (RED): This LED will light up when the signal begins to suffer distortion.

PROT LED (RED): This LED will light up for the following reasons (see the diagnostic table on the back

cover):

A) Short circuit in the speakers

B) Excessive temperature

POWER LED (BLUE): This indicator LED will light up when it is activated by the remote control signal

from the receiver or player.

Installing the Input Cables

In order to install the power supply, Use the appropriate cable as specified for the model chosen. The

positive cable should come straight from the battery and have a fuse or protective breaker 30 cm from the

battery. The negative cable should have the same gauge as the positive cable and be screwed to the chassis

of the vehicle, being careful to avoid paint and rust. These may interfere with the flow of the electrical

current and cause loss of power and interference in the sound.

REMOTE (REM)

Installation Recommendation

Model

Fuse

DDM5000.1

250A

DDM8000.1

400A

DDM10500.1

500A

ATTENTION: The use of a the fuse or breaker is required,

since this amplifier has no internal fuses.

: Connect the terminal

: Connect the cable to the chassis of the vehicle. Note: always connect the

Power/Ground

REM

2 AWG

20 AWG

00 AWG

20 AWG

00 AWG

20 AWG

to the positive terminal of the battery (+12V).

C) Low battery voltage

D) High battery voltage

FUSE

RECOMMENDED USE OF

AUXILIARY BATTERY.

Ground