Electrolux 27 SINGLE OVEN Podręcznik - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik dla Piekarnik Electrolux 27 SINGLE OVEN. Electrolux 27 SINGLE OVEN 8 stron.

Drukuj stronę

INSTALLATION (Following)

Insert appliance into cut-out. Use the anti-tip screws to

fasten the front frame of the appliance to the cabinet. The

mounting holes in the front frame of appliance may be

used as a template to locate the appliance mounting screw

holes.

To fasten the appliance to the cabinet:

1. Line up the 2 mounting holes on the grill (taped to the

oven side panel) with the lower mounting holes on each

side of the oven frame, below the oven door (see figure 3).

Pull the armored cable through the hole in the floor while

pushing in the appliance.

2. Use 2 screws from the miscellaneous parts bag to

secure the grill and appliance to the cabinetry.

3. Use the remaining 2 screws for mounting the appli-

ance in the upper two mounting holes on each side of the

oven frame, above the door.

MTG. SCREW

LOWER VENT GRILL

MTG. SCREW

FIGURE 3

19-3/8"

MINIMUM

REQUIREMENT

FOR

COMPLETE

OVEN DOOR

OPENING.

FIGURE 4

4. ELECTRICAL REQUIREMENTS

OBSERVE ALL GOVERNING CODES

AND LOCAL ORDINANCES

A. A four-wire 120/208 Y Volt or a 120/240 Volt, 60 Hz

AC only electrical supply is required on a separate circuit

fused on both sides of the line (time-delay fuse or circuit

breaker is recommended). DO NOT fuse neutral. The fuse

size must not exceed the circuit rating of the appliance

specified on the unit nameplate.

NOTE: Wire sizes and connections must conform with the

fuse size and rating of the appliance in accordance with

the Canadian Electrical Code and local codes and ordi-

nances.

WARNING: AN EXTENSION CORD SHOULD NOT BE USED

WITH THIS APPLIANCE. SUCH USE MAY RESULT IN A FIRE,

ELECTRICAL SHOCK, OR OTHER PERSONAL INJURY.

B. The appliance should be connected to the fused

disconnect (or circuit breaker) box through flexible armored

or nonmetallic sheathed cable. The flexible armored cable

extending from the appliance should be connected directly

to the junction box. The junction box should be located as

shown in Figure 2 with as much slack as possible remaining

in the cable between the box and the appliance, so it can

MTG. SCREW

be moved if servicing is ever necessary.

C. A suitable strain relief must be provided to attach the

flexible armored cable to the junction box.

SIDE

VIEW

- 3 -

IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE

LOCAL ELECTRICAL INSPECTOR'S USE.