DRAKE DAD860 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów DRAKE DAD860. DRAKE DAD860 15 stron. Digital to analog decoder
Również dla DRAKE DAD860: Instrukcja obsługi (15 strony)
Drukuj stronę
8
DAD860 Setup and Programming
INTRODUCTION
The programming of each DAD860 in an RMM12
rack mounting frame is done with the DAD860
Controller, or by a PC running Drake 'DAD860
Remote Control Software'. The following discussion
will describe the use of the DAD860 Controller. Use
of 'DAD860 Remote Control Software' will be
covered in documentation included with the soft-
ware.
The UNIT button on the DAD860 Controller is used
to select the unit to be programmed. The actual
programming is done via the UP, DOWN, LEFT,
RIGHT and ENTER buttons.
The chart below shows each of the menus that are
available for parameter value setup and/or viewing
for the DAD860 being programmed. Pressing the
LEFT or RIGHT arrow buttons will navigate through
these menus. You may do this without danger of
disturbing any of the current settings when not in
program mode.
As you navigate through the menus the parameter
name is listed on the top line of the display and the
current value is shown on the bottom line. For
setup purposes, it is best to progress clockwise
through the chart (use the right arrow button),
starting from the default UNIT # screen.
In the chart below shows the values that are avail-
able in each of these menus.
SYSTEM
DRAKE
UNIT #
BOOT UP
DAD860
SN xx dB
DAD860 CONTROLLER
MENU FLOW CHART
CH PLAN
RF LIST
OFF AIR
USE LIST
CATV STD
MAN SEL
CATV HRC
SCAN ADD
CATV IRC
SCAN NEW
CLR LIST
NO MUTE
VERSION
MUTE SCR
WEAK SIG
NUMBER
BLUE SCR
NO MUTE
NO VID
PROGRAMMING
To adjust and set a parameter value, enter the
program mode by pressing the center ENTER
button for approximately 3 seconds until the display
begins to flash. You are now in the program mode
and the UP and DOWN buttons will take you
through the various values for a given parameter.
Find the desired value for the selected parameter
and use the RIGHT arrow button to save that value
and progress to the next parameter, while remaining
in the program mode. (If the ENTER key is used,
the parameter value will be saved and program
mode exited.)
Proceed in this manner until all parameters have
been set to the desired value. Then press the
ENTER button to exit program mode and use the
UNIT key to proceed to the next DAD860 to be
programmed.
Pressing the LEFT arrow button while in program
mode will back up to the previous parameter without
saving the current parameter value to memory.
Once programming for a given DAD860 has been
completed, the information will be retained in the
units memory until it is reprogrammed, even when
power is removed.
Current
USE LIST
Channel
Select
MPEG
MAN SEL
Channel
PGM
Select
Scanning
SCAN
Channel
ADD
ADD
SCAN
Scanning
CONFIRM?
NEW
NEW
CLR LIST
CONFIRM?
CLEARING
AUDIO
VOLUME
0 - 100
1. ENG
2. SPA
MUTE
3. FRE
Select
RF
#
MPEG #
MPEG #
TV TYPE
MODE
STRETCH
4:3
LTR BOX
16:9
CROPPED
AFD/ LTR.
AFD/CROP