Bosch 300 Series Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Spryskiwacz Bosch 300 Series. Bosch 300 Series 32 stron. Built-in wall ovens
Również dla Bosch 300 Series: Instrukcja obsługi (40 strony), Podręcznik użytkownika (21 strony), Instrukcja instalacji (6 strony), Instrukcja instalacji (36 strony), Instrukcja obsługi i konserwacji / instrukcja instalacji (40 strony), Instrukcja obsługi (50 strony), Skrócona instrukcja obsługi i bezpieczeństwa (7 strony), Instrukcja instalacji (28 strony), Skrócona instrukcja obsługi (7 strony), Instrukcja obsługi i konserwacji (32 strony), Skrócona instrukcja obsługi i bezpieczeństwa (7 strony), Instrukcja serwisowa (36 strony), Skrócona instrukcja obsługi i bezpieczeństwa (13 strony)

Drukuj stronę
Bosch 300 Series Instrukcja instalacji

Checklist for Installation

Use this checklist to verify that you have completed each
step of the installation process. This can help you avoid
common mistakes.
Refer to detailed instructions for each step in the
sections following this checklist.
Before installing the appliance, be sure to verify the
1.
cabinet dimensions are correct for your appliance and
that the required electrical connections are present.
Make sure the electrical cord provided on the
appliance is able to reach to the point of connection.
Sections: Location requirements, Electrical installation
Move the appliance into place in front of the cabinet
2.
opening.
Section: Removing Packaging
Remove packaging materials, leaving the bottom
3.
packaging on the appliance to avoid damage to the
floor.
Section: Removing Packaging
Remove the mounting plate from the rear of the
4.
appliance.
Section: Install Appliance - Removing the mounting
plate
Find wall studs.
5.
Section: Install Appliance - Finding the wall studs

Before you begin

Removing Packaging

Remove filter, accessories and hardware. Do not
1.
remove the Styrofoam protecting the front of the oven.
Fold back all four carton flaps fully against carton
2.
sides. Then carefully roll the oven and carton over onto
the top side. The oven should be resting in the
Styrofoam.
Pull the carton up and off the oven.
3.
Cut the middle of the outer protective plastic bag to
4.
remove the mounting plate.
Attach the mounting plate to the wall.
6.
Section: Install Appliance - Attaching the mounting
plate to the wall
Adapt the microwave blower.
7.
Section: Install Appliance - Adapting the microwave
blower
Prepare the cabinet for mounting.
8.
Section: Install Appliance - Preparing cabinet
At least two persons are needed to lift the appliance;
9.
tilt and hook the appliance to the holding plate.
Section: Install Appliance - Mounting the microwave
oven
Push the appliance all the way into place and fasten
10.
the holding screws through top cabinet holes.
Section: Install Appliance - Mounting the microwave
oven
Use correct hood exhaust.
11.
Section: Install Appliance - Hood exhaust
Test the microwave oven for proper functioning.
12.
Section: Testing operation
Always read and follow the complete installation
instructions contained in this manual.

Tools and parts needed

Philips head screwdriver
▯
Pencil
▯
Ruler or tape measure and straight edge
▯
Drill
▯
Drill bits: 3/16", 1/2", 5/8"
▯
Gloves
▯
Saw (saber, hole or keyhole)
▯
Stud finder or hammer
▯
Safety goggles
▯
Level
▯
Duct and masking tape
▯
Optional tools
Carpenter square
▯
Tin snips (to cut damper and to remove knockouts)
▯
Scissors (to cut cabinet template)
▯
Filler blocks or scrap wood pieces (for recessed
▯
bottom cabinet installations)
5