Bosch Nexxt 800 WFMC8401UC Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Bosch Nexxt 800 WFMC8401UC. Bosch Nexxt 800 WFMC8401UC 35 stron. Nexxt 800 series washer
Również dla Bosch Nexxt 800 WFMC8401UC: Instrukcja obsługi, konserwacji i instalacji (24 strony), Arkusz specyfikacji (1 strony), Instrukcje instalacji (2 strony), Podręcznik dotyczący energii (2 strony)
Drukuj stronę
Water drainage
ATTENTION
Do not bend or pull the water
drainage hose.
Height difference between the
installation location of the washing
machine and the drainage point:
Maximum 8 feet / 244 cm, minimum 2
feet / 60 cm.
Connecting the water
drainage hose
Do not remove the screw from
q
the clamp assembly. Loosen the
screw only enough so that the
clamp will slide freely onto the
water drain hose.
1.
Place the hose clamp over the end
of the drain hose before attaching
the drain hose to the appliance.
2.
Attach the drain hose to the drain
hose connection on the back of
the appliance; position the hose
clamp approximately 3/8 inch (9
mm) from the end of the hose.
3.
Tighten the clamp with a
screwdriver
Standpipe Installation
Use the elbow. Attach the elbow to
q
the end of the hose and insert end
of hose into standpipe.
Use a strap or cable tie to hold
q
hose in place.
In-Wall Installation
Use the elbow. Attach the elbow to
q
the end of the hose and insert the
end of the hose into the wall drain.
The hose and elbow should
q
extend into the open drain pipe as
far as the elbow allows when
seated as shown in the above
picture.
Use a strap or cable tie to hold
q
hose in place.
Drainage into a siphon
Secure the connection point with a
q
hose clip(not included in
factory-supplied equipment).
Drainage into a sink
ATTENTION
Ensure that the plug is not in the
drain hole.
Attach water drain hose securely
q
to sink.
Use a strap or cable tie to hold
q
hose in place.
When the water is being drained,
q
check that the water flow out of
the sink is adequate.
9