Bosch Programme Table Instrukcja obsługi - Strona 8

Drukuj stronę

Bosch Programme Table Instrukcja obsługi

What to do if ...

Water is leaking out.

– Attach/replace the drainage hose correctly.

– Tighten the screw connection of the supply hose.

No water supply.

–

Start/Reload not selected?

Detergent not

– Tap not turned on?

dispensed.

– Filter blocked? Clean the filter -> page 10.

– Supply hose kinked or trapped?

Washing machine door

– Safety function active. Programme stopped? -> page 4.

cannot be opened.

–

(without final spin) selected? -> page 3, 4.

– Can be opened by emergency release only? -> page 9.

Programme does not

–

Start/Reload or

start.

– Washing machine door closed?

– Childproof lock active? Deactivate -> page 5.

Detergent solution is

–

(without final spin) selected? -> page 3, 4.

not drained.

– Clean the detergent solution pump -> page 10.

– Clean the waste pipe and/or drainage hose.

Water not visible in the

– Not a fault - water below the visible area.

drum.

Unsatisfactory spin

– Not a fault - the unbalanced-load detection system has cancelled

result.

the spin cycle because of uneven distribution of the laundry.

Laundry wet/too damp.

Distribute small and large items of laundry evenly inside the drum.

–

Reduced Ironing selected? –> page 5.

– Selected speed too low? –> page 5.

The programme length

– Not a fault - the number of spin cycles may be changed due to

jumps during the final

the varying distribution of the laundry, which may cause the time

spin.

in the display panel to be corrected.

Spin cycle performed

– Not a fault - unbalanced load detection system adjusts the

several times.

imbalance.

Residual water in the

– Not a fault - the action of the care product is not affected.

compartment for care

– Clean the insert if necessary -> page 9.

products.

Odour formation in the

– Run programme

washing machine.

standard detergent.

Status display

– Too much detergent used?

flashing.

If foam is escaping from the detergent drawer:

Appliance has detected

Mix 1 tablespoon of fabric softener with ½ litre of water and pour

a detergent overload.

into compartment II (not with outdoor or down fabrics).

– Reduce the detergent dosage for the next wash cycle.

Intense noise formation,

– Are the appliance feet fixed?

vibrations and

Secure the appliance feet –> Installation instructions.

"wandering" during the

– Transportation safety devices removed?

spin cycle.

Remove the transportation safety devices –> Installation

instructions.

Display panel/indicator

– Power cut?

lamps do not function

– Fuses triggered? Reset/change the fuse.

during operation.

– If the fault occurs repeatedly, call customer services.

Programme sequence

– Not a fault - unbalanced load detection system adjusts imbalance

longer than usual.

by repeatedly distributing the laundry.

– Not a fault - foam detection system active - adds an additional

rinse cycle.

Detergent residues

– Occasionally, phosphate-free detergents contain water-insoluble

on the laundry.

residues.

– Use the

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and remove the mains plug from the socket.

– Turn off the water supply and call customer services –> Installation instructions.

Ready in time selected?

Cottons 90 °C without laundry. Use

Rinse cycle or brush out the laundry after washing.

Observe the safety instructions on page 8.

Read these instructions and the separate installation instructions before

operating the washing machine.

Washing machine

Instruction manual