Bosch Series 4 Instrukcja obsługi - Strona 9

Drukuj stronę

Open the appliance door as infrequently as possible

■

when the appliance is in use.

It is best to bake several cakes one after the other.

■

The cooking compartment stays warm. This reduces

the baking time for the second cake. You can place

two cake tins next to each other in the cooking

compartment.

For longer cooking times, you can switch the

■

appliance off 10 minutes before the end of the

cooking time and use the residual heat to finish

cooking.

Saving energy with the gas hob

Always use a saucepan which is the correct size for

■

your food. A larger, less full saucepan requires a lot

of energy.

Always place a suitable lid on the saucepan.

■

The gas flame must always be in contact with the

■

base of the saucepan.

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly

manner.

This appliance is labelled in accordance with

European Directive 2012/19/EU concerning

used electrical and electronic appliances

(waste electrical and electronic equipment -

WEEE). The guideline determines the

framework for the return and recycling of used

appliances as applicable throughout the EU.

Installation and connection

5Installation and connection

I n s t a l l a t i o n a n d c o n n e c t i o n

Gas connection

Installation must only be performed by an approved

expert or a licensed after-sales service engineer in

accordance with the instructions specified under "Gas

connection and conversion to a different gas type".

For the licensed expert or after-sales service

Caution!

The setting conditions for this appliance are

■

specified on the rating plate on the back of the

appliance. The gas type set in the factory is marked

with an asterisk (*).

Before setting up the appliance, check the grid

■

access conditions (gas type and gas pressure) and

ensure that the gas setting of the appliance meets

these conditions. If the appliance settings have to be

changed, follow the instructions in the section "Gas

connection and conversion to a different gas type".

This appliance is not connected to a waste gas

■

main. It must be connected and commissioned in

accordance with the installation conditions. Do not

connect the appliance to a waste gas main. All

ventilation regulations must be observed.

The gas connection must be made via a fixed, i.e.

■

not mobile connection (gas line) or via a safety

hose.

If using the safety hose, ensure that the hose is not

■

trapped or crushed. The hose must not come into

contact with hot surfaces.

* The gas line (gas pipe or gas safety hose) can be

■

connected to the right- or left-hand side of the

appliance. The connection must have an easily

accessible shut-off device.

* Optional. Available for some appliances.

Target appliance operating pressure

Your appliance's target operating pressure is specified

on the rating plate on the back of the appliance.

All the data on your appliance's rating plate relates to

these pressure values. The manufacturer shall not be

held liable for results, performance or any risk caused

by operating the appliance at pressure values other

than those specified.

Warning – Safety information!

If the gas pressure in your distributing pipes is higher

(20%) than the values specified on the appliance's

rating plate, it is important that you operate the

appliance with a suitable gas governor for your safety.

If you do not know what the gas pressure in your

distributing pipes is, contact your local gas company.

The gas governor must be connected, maintained and

adjusted by specialists from your local gas company.