Draper Foundation Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ekran projekcyjny Draper Foundation. Draper Foundation 17 stron. Foundation for led panels
Drukuj stronę
Foundation
for LED Panels
™
Important Safety Information
WARNING
Improper installation and use of Foundation for LED Panels can result in serious injury or death. Primarily, injuries can occur when the Foundation for LED
Panels falls due to imprecise installation, mishandling of the Foundation for LED Panels during installation or installation on an insufficient wall or ceiling
structure. Please use extreme care.
1. Please read the following installation guidelines thoroughly and follow them carefully. Failure to do so may cause product to fall or otherwise fail, and could
result in serious injury.
2. Installation and use of any video wall display should be conducted with approved clearances for operating and servicing the display along with adequate
ventilation for cooling. Consult your display manufacturer for operation, ventilation, and servicing conditions and requirements. Draper does not make
recommendations related to proper operation of any display nor will Draper accept liability for a display which fails due to improper installation, use, or
ventilation.
3. Installation and calibration of the Foundation for LED Panels should only be performed by an authorized, qualified, and experienced professional. In particular,
electrical work and wiring [indicated in diagram by dashed lines] must be completed only by a qualified professional electrician who has read this manual
completely and is familiar with the construction and operation of this equipment and the hazards involved.
4. Turn off power and any nearby equipment or cables carrying electricity before connecting switches, wires, controls, or electrical components.
5. Do not affix the unit to wall or ceilings that have inadequate strength to permanently hold the unit during use. It is the owner's and installer's responsibility to
confirm the wall to which the unit attaches is sufficient to permanently hold the weight and stress loads of the unit at all times. Draper, Inc., is not responsible
for improper installation, application, testing or workmanship related to the product at place of installation.
6. It is the installer's responsibility to make sure appropriate fasteners are used for mounting.
7. All brackets and other hardware must be installed level. Foundation for LED Panels must be level and square.
8. Never leave the area while operating the Foundation for LED Panels during installation, maintenance, or normal operation, unless it is secure and safe.
9. Before testing or operation, carefully inspect the entire area and areas underneath to be sure no persons or objects are in the area.
10. During testing or operation, carefully watch the surrounding area for any potential safety concerns including nearby persons or objects.
11. After installation, the entire system should be carefully tested to ensure safe and normal operation.
Extreme care should be taken during testing to remain clear of moving parts to avoid possible injury.
12. Operation of Foundation for LED Panels should be performed only by authorized and qualified personnel, who have been trained in the safe and effective
operation of the Foundation for LED Panels & understand its safety features.
13. The safety features of the Foundation for LED Panels should never be disabled, bypassed or overridden.
The system should not be operated until all safety features are properly and completely installed, calibrated and tested.
14. Foundation for LED Panels may need to comply with local, state or district rules and regulations, in particular when installed in schools.
All applicable rules and regulations should be reviewed before installation and use.
15. Failure to precisely follow installation guidelines invalidates all warranties.
16. Custom products/installations may not be reflected in this manual.
Call Draper, Inc., if you have questions about the installation of custom products or any questions about your installation.
Before Beginning Installation
1. Look for any job site conditions that could interfere with installation or operation of the system.
2. Read carefully and be sure to understand all installation instructions and all related operations manuals. These instructions are intended to as a guide for the
installer and owner. They should be followed closely and combined with the expertise of experienced qualified installers. Draper, Inc., is not responsible for
improper installation, application, testing or workmanship related to the product at place of installation. Please retain all instructions for future use.
3. Open cartons lengthwise.
4. Locate and lay out all pieces.
5. Inspect all boxes to make sure you have received the proper Foundation for LED Panels and parts.
6. If you have any difficulties with installing, servicing or operating your Foundation for LED Panels, call your dealer or Draper, Inc., 765 987-7999.
Foundation
for LED Panels
™
Overview
LED Panels
Section 1 - Personnel and Tools Required
PERSONNEL REQUIRED
1
2
WORK GLOVES
RECOMMENDED
INSTRUCTIONS
ASSEMBLY & INSTALLATION
Optional
Vented
Trim Frame
Y-Axis
Adjustable
Vertical
Rails
Z-Axis Adjustable
Horizontal Rail
POWER DRILL
TAPE MEASURE
LASER LEVEL
HEX WRENCH
3mm & 5mm
If you have any difficulties installing or servicing your
Foundation for LED Panels, call your dealer or Draper, Inc.
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385
draperinc.com | 765.987.7999 | 800.238.7999
|
© 2021 All Rights Reserved
FORM: FDN_NEOTI_Inst21
LEVEL