Draper Nocturne Series Instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Ekran projekcyjny Draper Nocturne Series. Draper Nocturne Series 4 stron. 220v exterior projection screen
Drukuj stronę
Nocturne Exterior Projection Screen by Draper
Nocturne Exterior Projection Screen—Crank and Motorized Dimensions
Total width = Viewing Surface width + 3
OR
Figure 5
www.draperinc.com
Electrical Connections
Screen operates on 220V, 50Hz. or 60 Hz. 1 ph. current. Screen is shipped
with internal wiring complete and control switch (es) fully boxed, and supplied
with a 6' cable lead. Longer lead can be substituted by removing two screws
in motor end of roller, removing lead, plugging new lead in, and replacing
screws. Wire to connect shade to switch (es) and switch (es) to power supply
should be furnished by installer. Connections should be made in accordance
with attached wiring diagram, and wiring should comply with national and
local electrical codes. DO NOT wire motors in parallel without written
permission from Draper.
All operating switches should be "off" before power is connected.
Limit Switch Adjustments—Standard Motor
Please Note: Screen limits are factory set for optimum performance of
the screen. A procedure is outlined below for minor tweaks, but any ad-
justment of these limits may negatively affect the flatness of the screen
surface and could also void the warranty. Please check with Draper prior
to resetting screen limits.
CAUTION: Always be prepared to shut screen off manually when new
adjustment is being tested. Screen may be severely damaged if viewing
surface is allowed to run too far up or too far down.
CAUTION: Be sure all switches are in "off" position before adjusting
limit switches.
Push Button Limits
1 Fully depress both limit switch push buttons, then operate wall
switch to make sure system works properly.
2 Raise screen to desired "up" stop position.
3 Set upper limit by depressing and releasing the proper (back)
push button.
4 Lower screen to desired "down" stop position.
5 Set lower limit by depressing and releasing the proper (front)
push button.
Screw-Type Limits
1 Determine which direction of travel corresponds with arrows on
motor.
2 Operate screen to desired "down" stop position. Set limit by
turning the proper socket toward the "+" to lower the limit, and
"-" to raise it.
3 Operate screen to desired "up" stopping position. Set limit by
turning the proper screw toward the "-" to raise the limit, and "+"
to lower it.
/
"
5
16
1
/
21
32
(765) 987-7999
Page 2 of 4
5"
/
"
5
8
1
/
"
13
4"
2
/
"
13
16
16
Back
½"
"
Motor End
+
+
1
Motor End
/
"
7
8
1½"
Top