Bosch WAB28162GB Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Bosch WAB28162GB. Bosch WAB28162GB 8 stron.
Drukuj stronę
Safety instructions
Before washing for the first time
– Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
– Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn-out appliances:
Care
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and risking their lives.
Danger of suffocation
– Keep packaging, film and packaging parts out of the reach of
children.
Risk of poisoning
– Keep detergents and care products out of the reach of children.
Risk of explosion
– Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover/cleaning solvent may cause an
1. Pull out, press insert down, remove drawer completely.
explosion after being loaded into the washing machine.
2. To remove the insert: press the insert upwards from below with your
Rinse items of laundry thoroughly by hand beforehand.
3. Clean the detergent dispenser tray and insert with water and a brush and
Risk of injury
– The washing machine door can become very hot.
– Be careful when draining hot detergent solution.
4. Attach the insert and engage (connect the cylinder to the guide pin).
– Do not climb onto the washing machine.
5. Push in the detergent drawer.
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine
is in operation.
Consumption values
Programme
Load
Energy***
Water***
Programme duration
(h)***
Cottons 20 °C
6 kg
0.30 kWh
68 l
2
h
Cottons 40 °C*
6 kg
0.95 kWh
68 l
2
h
Cottons 60 °C
6 kg
1.60 kWh
68 l
2
h
Information on the display panel
Cottons 90 °C
6 kg
2.45 kWh
76 l
2
h
Easy-Care 40 °C*
3 kg
0.70 kWh
46 l
1
h
:
Mixed Load 40 °C
2,5 kg
0.40 kWh
44 l
1 h
:
Delicates/Silk 30 °C
2 kg
0.30 kWh
37 l
h
Wool 30 °C
2 kg
0.20 kWh
43 l
h
*
Programme setting for testing in accordance with currently applicable EN60456 standard.
:
Note on comparative tests: When testing the test programmes, wash the specified load using the maximum
spin speed.
Programme
Load
Annual energy consumption Annual water consumption
:
Cottons
(Eco)**
6/3 kg
153 kWh
10560 l
** Programme settings for testing and energy labelling in accordance with EU directive
2010/30/EU with cold water(15 °C).
Other
*** The values may deviate from the specified values depending on water pressure, water hardness, and
displays
inlet temperature, ambient temperature, type, amount and level of laundry soiling, detergent used, fluctu-
ations in the power supply and selection of options.
8
8
7
Maintenance
Detergent solution pump
Do not load any laundry into the machine. Turn on the tap. Add the following to compartment
II:
– approx. 1 litre water
Turn the programme selector to Off and disconnect the mains plug.
– detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
1. Remove the service flap for detergent solution pump.
Set the programme selector to Cottons 60 °C and select Start/Pause. At the end of the
2. Carefully unscrew the pump cover (residual water).
programme, turn the programme selector to Off.
3. Clean the interior, pump cover thread and pump housing (the impeller in
the detergent solution pump must rotate).
– Risk of electric shock.Disconnect the mains plug.
4. Replace the pump cover and screw it tightly.
– Risk of explosion. No solvents.
5. Place the service flap back.
Machine housing, control panel
To prevent unused detergent from flowing straight into the drain during the next wash:
– Remove detergent residue immediately.
Pour 1 litre of water into compartment II and start the Spin/Drain programme.
– Wipe off with a soft, damp cloth.
Drainage hose at the siphon
– Do not clean with a jet of water.
Turn the programme selector to Off and disconnect the mains plug.
Cleaning the detergent drawer ...
1. Loosen the hose clamp, carefully remove the drainage hose
... if it contains detergent or fabric softener residues.
(residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose
finger.
clamp.
dry it.
Filter in the water supply
Risk of electric shock
Do not immerse the HydroSafe safety device in water (contains an electric valve).
Leave the detergent drawer open so that any residual water can
evaporate.
Reduce the water pressure in the supply hose:
Drum
1. Turn off the tap.
2. Select any programme (except Spin/Drain).
Leave the washing machine door open so that the drum can dry out.
3. Select Start/Pause Let the programme run for approximately 40
Rust stains - use chlorine-free cleaning agent, not steel wool.
seconds.
Descaling
Ensure there is no laundry in the machine
4. Turn the programme selector to Off. Disconnect the mains plug.
This should not be necessary if the correct detergent dosage has been used. If it is necessary, however,
proceed according to the descaling agent manufacturer's instructions. Suitable descalers can be obtained via
5. Clean the filter:
our website or from our after-sales service (
page 1).
Disconnect the hose from the tap.
Clean the filter using a small brush.
depending on model
and/or for Standard and Aqua-Secure models:
Close the washing machine door properly; laundry may be caught.
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
Turn the (cold water) tap on fully;
6. Connect the hose and check the leak tightness of the
supply hose kinked/trapped;
connection points.
water pressure too low; service, clean the filter
page 10,
Detergent solution pump blocked; service, clean the detergent solution pump
page 10.
Drainage hose/waste pipe blocked; service, clean the drainage hose at the siphon
page 10.
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales service.
Childproof lock active; Deactivating
page 5.
Switch off the appliance, wait for 5 seconds and switch it back on again. If the display
appears again, call the after-sales service.
9
– Risk of scalding. Allow the
detergent solution to cool down.
What to do if ...
– Turn off the tap.
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
– Start/Pause not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
page 10.
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
Programme does not
– Start/Pause selected?
start.
– Washing machine door closed?
Detergent solution is not
– Clean the detergent solution pump
drained.
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin
– Not a fault - the unbalanced-load detection system has cancelled
result.
the spin cycle because of uneven distribution of the laundry.
Laundry wet/too damp.
Distribute small and large items of laundry evenly inside the
drum.
– Selected speed too low? –> page 5.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment
for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the
– Run programme Cottons 90 °C without laundry. Use standard
washing machine.
detergent.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and
Secure the appliance feet
Installation instructions.
"wanderring" during the
– Transportation safety devices removed?
spin cycle.
Remove the transportation safety devices
instructions.
Indicator lamps do not
– Power cut?
function during
– Fuses triggered? Reset/change the fuses.
operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence
– Not a fault - unbalanced load detection system adjusts
longer than usual.
imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on
– Occasionally, phosphate-free detergents contain water-insoluble
the laundry.
residues.
– Select Rinse or brush the laundry after washing.
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
Installation instructions.
10
page 10.
Installation
Washing machine
WAB28162GB
en operating instructions
11