Bosch WAE24377GB SERIES Instrukcja obsługi i instrukcja instalacji - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Bosch WAE24377GB SERIES. Bosch WAE24377GB SERIES 36 stron.

Drukuj stronę

Operating the appliance

E flashes: The childproof lock is

■

active and the programme selector

has been adjusted. To prevent the

programme from stopping, turn the

programme selector back to the

original programme. The symbol

lights up again.

The childproof lock can remain

Note:

activated until you wish to start the next

programme, even after switching off the

machine.

You must then deactivate the childproof

lock before starting the programme and

activate it again as necessary once the

programme has started.

Adding laundry

After starting the programme, you can

add or remove laundry as required.

To do this, press the Start/Reload

button.

The "Start/Reload" indicator lamp

flashes and the machine checks

whether it is possible to add laundry.

Do not leave the washing

Note:

machine door open for too long when

adding laundry as water from the

laundry may leak out.

If, on the display panel:

YES lights up, it is possible to add

■

laundry.

NO flashes, wait until YES lights up.

■

A flashing NO symbol, it is not

■

possible to add laundry.

For safety reasons, the washing

machine door remains locked when

the water level or temperature is

high, or while the drum is rotating,

and it is not possible to add laundry.

To continue the programme, press

the Start/Reload button. The

programme continues automatically.

Changing the programme

If you have started the wrong

programme by mistake, you can

change the programme as follows:

Select the other programme.

Press the Start/Reload button. The

new programme starts from the

beginning.

Cancel the programme

For programmes at high temperatures:

To cool the laundry, select Rinse/

Spin.

Press the Start/Reload button.

For programmes at low temperatures:

Press Start/Reload.

Select Rinse/Spin (deactivate the

Rinse plus/Water plus button) or

select Empty.

Press the Start/Reload button.

Programme end during rinse

hold

- - - appears on the display panel, the O

status display lights up and the "Start/

Reload" button indicator lamp flashes.

To end the programme, set the

programme selector to "Empty" or

select a spin speed. Then press the

Start/Reload button.

Programme end

-0- appears on the display panel and

the "Start/Reload" button indicator lamp

flashes.

If the N symbol also appears on the

display panel, the washing machine has

detected too much foam during the

wash programme and automatically

switched on a rinse cycle to remove the

foam.

Add less detergent for the next

Note:

washing cycle with the same load.