Bosch WAJ20065IN Podręcznik użytkownika i instrukcje instalacji - Strona 39

Przeglądaj online lub pobierz pdf Podręcznik użytkownika i instrukcje instalacji dla Spryskiwacz Bosch WAJ20065IN. Bosch WAJ20065IN 48 stron.

Fault
The programme dura-
tion changes during
the wash cycle.
No water is visible in
the drum.
Drum jerks after the
programme starts.
Residual water is
present in the com-
partment
.
Vibrations and move-
ment of the appliance
whilst spinning.
Heavy foam build-up
High spin speed not
reached.
Cause and troubleshooting
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
Water is below the visible area.
Not a fault – no action required.
Do not add any extra water to the appliance while it
is operating.
This is caused by an internal motor test.
Not a fault – no action required.
Insert in compartment
→ "Cleaning the detergent drawer", Page 30
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 15
The appliance feet are not fixed.
Secure the appliance feet.
→ "Aligning the appliance", Page 15
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
spin speed.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the  programme.
Troubleshooting en
is blocked.
39