Draper 19392 Podręcznik - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik dla Elektronarzędzie Draper 19392. Draper 19392 20 stron. 12v oscillating multi-tool

Drukuj stronę

8. Operating Instructions

Important: Before use, read and understand all the

safety instructions listed in this manual. Ensure that all

attachments are securely fixed before use. Secure any

loose workpieces before operating.

8.1 The Variable Speed Dial

(5)

Fig.

The speed of the tool's oscillation can be controlled

using the variable speed dial (5) on the side of the tool

housing. The higher the number selected, the quicker

the stroke rate of the tool.

Important: ALWAYS pre-set the tool speed before use.

CAUTION! The variable speed dial is not continuous

and cannot be rotated directly between values 6 and 1

and vice versa. DO NOT force the dial as this may

damage the tool.

8.2 The On/Off Switch

Important: Before switching on the tool, ensure that the

tool speed is appropriately set.

(4)

Fig.

Power is controlled by the sliding on/off switch (4).

• To switch the tool on, slide the on/off switch upwards

into the on ( ) position.

• To switch the tool off, slide the on/off switch

downwards into the off ( ) position.

8.3 Notes on Cutting, Sawing and

Scraping Operations

• Allow the tool to reach full speed before applying it to

the workpiece.

• Holding the tool firmly, place the accessory against

the workpiece and move the tool smoothly forward so

that the motion does not slow down.

• DO NOT force the tool in the direction of the

accessory's non-cutting edge.

• DO NOT exert excessive pressure on the tool.

• For cutting operations, Draper Tools recommends

speeds 3–5.

8.4 Notes on Sanding Operations

• Allow the tool to reach full speed before applying it to

the workpiece.

• Holding the tool firmly, apply the sandpaper gently

against the workpiece; DO NOT use excessive force.

• DO NOT use worn sandpaper or paper without grit.

• DO NOT use sandpaper for wood sanding if it has

previously been used to sand metal.

• Use a scrap piece of similar material to test the correct

tool speed before operating on the workpiece.

• DO NOT change the grit of the sandpaper accessory

until the whole area of the workpiece has been

completed.

– 14 –