Draper 58329 Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Elektronarzędzie Draper 58329. Draper 58329 16 stron.

BASIC HEAT GUN OPERATIONS

Note: The following instructions should only be

used as a guide as the ideal temperature should be

ascertained by performing a test on the workpiece.

Heating efficiency will vary depending on the

properties of the workpiece, and the distance kept

between the metal nozzle and the workpiece itself.

8.4 PAINT REMOVAL FROM WINDOW

FRAMES – FIG.3

Important: Do not direct the hot air gun at the glass

during use as it may crack. Always use the glass

protection nozzle (7). Do not touch the glass with

the hot nozzle.

8.5 HEATING AND SHAPING PLASTIC

TUBING – FIG.4

Fit the reflector hook nozzle (9). Switch the hot air

gun on to the low heat setting and, carefully heat

the tubing evenly moving it from side to side.

– FIG.5

Important: Do not defrost plastic tubing/piping.

Fit the reflector hook nozzle (9). Switch the hot air

gun on to the higher heat setting and, gently heat

the frozen area of the pipe starting from the edge of

the area and moving in towards the centre.

Important: Take care not to heat the pipe too

quickly as this could cause the pipe to crack and

burst. Do not overheat water pipe joints as these

are only soldered together (max. 200ºC).

FIG.3

FIG.4

(9)

FIG.5

- 12 -

(7)

(9)