Bosch WAJ28008GB/12 Podręcznik użytkownika i instrukcje instalacji - Strona 41
Przeglądaj online lub pobierz pdf Podręcznik użytkownika i instrukcje instalacji dla Spryskiwacz Bosch WAJ28008GB/12. Bosch WAJ28008GB/12 48 stron.
Fault
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Water is leaking out at
the water inlet hose.
Cause and troubleshooting
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Spin programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Rinse programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 14
Tighten the screw connection.
2.
Troubleshooting en
41