Draper Clutch Operated FlexShade Instrukcja instalacji i obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wyposażenie wnętrz Draper Clutch Operated FlexShade. Draper Clutch Operated FlexShade 7 stron.

Drukuj stronę

Clutch Operated FlexShade

Window shade with smooth, quiet operation, and independent control

Section 4 - Endcaps with Fascia

Section 4.1 - Attaching Fascia to Endcaps

1. Place groove along top of fascia over endcaps, and snap into place

Endcaps must be installed the correct distance apart for fascia to be properly attached

with full engagement. Fascia is not fully seated until it clicks into place on both ends.

Once in place, check for secure fit. If not secure, secure with appropriate fastener

Section 4.2 - Reverse Roll Fascia

1. Slide endcaps into extrusions.

2. Using provided holes in endcaps, mark the fascia for drilling.

3. Attach endcaps to fascia.

4. Mount Endcaps/Reverse Roll Fascia.

5. Install roller/fabric/operator assembly according to relevant instructions.

6. Attach endcap covers to endcaps. Use double-sided tape to help secure in place.

Section 5 - Surface Headbox or Pocket Headbox

1. Snap endcap covers onto endcaps.

2. Slide endcaps into the top/back portion of surface headbox or into pocket extrusion of headbox.

Using provided holes in endcaps, mark headbox for drilling.

Please Note: The installer is responsible for selecting mounting hardware appropriate for site conditions.

Caution: Before mounting shades, verify measurements on the provided with shade,

and ensure endcaps are installed at correct width.

(wall mount)

3. Drill holes in back

4. Attach Surface or Pocket Headbox extrusion to wall, ceiling or pocket using mounting hardware

appropriate for site conditions.

(See Section 2 - Bead Chain Clutch Installation -

5. Install shade

6. Attach headbox fascia or pocket closure

Note on surface style headbox:

Fascia is not fully seated until it clicks into place on both ends. Once in place,

check for secure fit. If not secure, secure with appropriate fastener

(see Fig. 9)

(ceiling

mount).

or top

Endcaps).

(see Fig.

10).

(see Fig.

8).

(not

included).

Large Pocket Headbox

STEP 1

STEP 2

(not

included).

STEP 3

page 6 of 7

Fascia Attachment Small & Large Endcaps

ATTACHING FASCIA

STEP 2:

STEP 1:

ENDCAP

Clicks into place

Figure 8

Figure 9

ATTACHING CLOSURE PANEL

Small Pocket Headbox

Large Pocket Headbox

STEP 1

STEP 2

STEP 3

Secure to Endcap

with Screw

Figure 10

Small Pocket H

STEP 1

STEP 2

STEP

STEP 3

Secure to E

with Screw