Draper LightBloc ZIP 127 Instrukcja instalacji i obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wyposażenie wnętrz Draper LightBloc ZIP 127. Draper LightBloc ZIP 127 12 stron.

Drukuj stronę

LightBloc ZIP™ 92 & ZIP 127

Section 1 - Site Preparation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

MOUNTING

1 "

BRACKET

(44 mm)

E N

D C

Figure 1

A P

Section 2 - Curved or Square Headbox Mounting

Section 2.1 - Wall Installation

1. Drill small starter holes

(if necessary)

2. Attach Mounting Brackets to the wall using #10 flat head screws installed flush with bracket.

Please Note: Be sure to use AT LEAST 2 of the top mounting holes

3. Ensure brackets are level.

4. Attach Headbox to brackets and

tighten Set Screws

(Fig. 3-A)

5. Mount the Side Channels

(Section 5)

Figure 3-A

Section 2.2 - Ceiling Installation

1. Attach Mounting Brackets

to ceiling using #10 flat head

screws installed flush with

bracket. USE ALL FOUR

(4)

mounting holes

(Fig. 3-B)

2. Attach Headbox to brackets

and tighten Set Screws

(Fig. 3-B)

3. Mount the Side Channels

(Section 5)

1. Ensure mounting surface is strong enough to hold unit.

2. Verify unit measurements, ensuring it will fit

in the desired location.

Caution: Hem Bar does not retract into

the Headbox. Provide at least 2 1/4"

clearance if mounting over a swinging

window or door.

3. Mounting Brackets MUST be installed with

a gap of 1 3/4"

between the Endcap

(44mm)

and the Mounting Bracket edge

Mark wall, jamb, or ceiling.

4. Determine which Headbox style is being

installed

(Fig. 2)

PLEASE NOTE: Refer to appropriate sections within this document

for different installation options:

SECTION 2: Mounting Unit with Brackets

SECTION 4: Mounting Unit Directly to Ceiling or Wall

SECTION 6: Installing Angled Headbox

in mounting surface.

(Fig. 3-A)

Figure 3-B

LightBloc ZIP

(57mm)

92 Square

Headbox

(127mm)

(Fig. 1)

LightBloc ZIP 127

Square Headbox

(Curved or Square Headbox ONLY)

(Curved Headbox shown)

Figure 2

HEADBOX STYLES

3 "

(92mm)

3 "

(92mm)

(127mm)

LightBloc ZIP 127

Angled Headbox

page 3 of 12

(92mm)

LightBloc ZIP

92 Curved

Headbox

(127mm)

LightBloc ZIP 127

Curved Headbox

Tighten Set Screws