Draper Motorized FlexShade Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie wnętrz Draper Motorized FlexShade. Draper Motorized FlexShade 12 stron. Motor operated window shades with several control options
Również dla Draper Motorized FlexShade: Instrukcja instalacji i obsługi (8 strony)

Drukuj stronę

Motorized FlexShade

RECOMMENDED

PERSONNEL

Section 1 - Operating the Retractable Coupler Shaft

Please Note: Custom products/installations may not be reflected by this document.

The Draper

Coupled FlexShade

The retractable coupler shaft has three distinct positions: fully extended, intermediate, and fully retracted.

1. To retract the coupler shaft from fully extended to the intermediate position, grasp the roller with one hand,

while using the included Spanner Wrench to rotate the metal Locking Ring counterclockwise

approximately ½ of a turn with the other, leaving the shaft extended approximately ½"

the coupler assembly)

2. To retract the coupler shaft fully, rotate the metal Locking Ring counterclockwise

an additional 1/3 of a turn.

facing the coupler assembly)

3. To lock shaft in place when extended, rotate metal Locking Ring clockwise ¼ turn.

Please Note: There is no retractable shaft in the idler end assembly on the idler end shade

. This idler assembly utilizes a sliding pin and retainer clip.

(furthest from the operator)

Please Note: These instruction steps are for installing endcaps one at a time.

Endcaps may also all be installed at the same time, prior to installing roller/fabric assemblies.

If endcaps are installed first, be certain of measurements and locations. For best results,

assemble the unit on a flat, clean surface. Verify measurements before attaching endcaps.

Section 2 - Couplers, Brackets, and Endcaps

Caution: Before mounting shades, verify measurements on the card provided with the shade, and ensure the endcaps are installed at the correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

Caution: DO NOT use wall brackets for ceiling installations, and DO NOT use ceiling brackets for wall installations.

Ceiling

Wall

Idler End Bracket

Idler End

Endcap

(Coupled)

Please Note: Draper recommends that a team of at least two

Caution: Before beginning installation, practice extending and retracting the coupler shaft in a fabric/roller

assembly, following instructions in the "Operating the Retractable Coupler Shaft" section below.

Caution: All motors should be tested and limits set using test cord before electrician wires shade.

utilizes a locking retractable shaft to hold roller assemblies in place and link panels together.

Ceiling

Coupler Bracket Assembly

Coupler Endcap Assembly

Fascia/Headbox

people install this product.

(2)

(as viewed facing

(13mm)

(as viewed

SHAFT

EXTENDED

(Intermediate)

Wall

page 3 of 12

SHAFT

FULLY

EXTENDED

HALF

SHAFT

RETRACTED

Ceiling

Motor End Bracket

Motor End

Endcap

FULLY

Wall