Draw tite CQT76154 Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Akcesoria samochodowe Draw tite CQT76154. Draw tite CQT76154 4 stron. Nissan titan 2017-

Drukuj stronę

Rear

Remove tow hook brackets – Using a 17mm socket, remove factory tow hook brackets (if present) by removing (10) M12 flange head bolts. Return bolts & brackets

to vehicle owner. See Figure 2. NOTE: For vehicles without factory tow hook brackets, it may be necessary to clean the existing weldnuts in frame using a wire brush

or compressed air.

Install hitch – Raise the hitch into position, raising the passenger's side hitch bracket above the exhaust first, then raise the driver's side into position. Using the

supplied hardware, install the M12 bolts, conical toothed washers, and hardened flat washers as shown. See Figure 1.

Tighten all M12 CL10.9 fasteners with torque wrench to 76 Lb.-Ft. (103 N*m)

Proper torque is needed to keep the hitch secure to the vehicle when towing.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been

damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

Installation Instructions

PART NUMBERS: 76154, 84154, CQT76154

Fasteners

typical

both sides

Existing weldnuts

(10) Places

Figure 1

②

①

②

①

②

①

Fastener Kit: 76154F

Bolt M12 X 1.25 X 40 CL10.9

①

Qty. (10)

Part no. 04263040

Conical washer ½

②

Qty. (6)

Part no. 01292008

Flat Washer ½ (Hardened)

③

Qty. (4)

Part no. 3306QAD

Always wear SAFETY GLASSES

when installing hitch

Conical Washer

Teeth side

Against hitch

Factory tow

hook bracket

Both sides

Figure 2