Drawell SMART-e-320 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Drawell SMART-e-320. Drawell SMART-e-320 16 stron.

Drukuj stronę

3. Installation and Carry

Please clean the operation desk before installation, for

example paper, cotton or packing waste, avoiding any

interference in installation.

Put the microscope from the foam and put it on the desk.

Make sure the power switch is off at "○"and the supply

voltage meets the instrument's requirement .

3.1 Installation Process

(1) Integrative head :

Loose G slightly (use attached wrench except knurled

thumb screw ),put ⑧ into ⑦ main body's joint, adjust

position, tight G again.

(2) Put out the dust cover for reservation .

(3) Eyepiece: pull out and plug in eyepiece tube.

(4) Condenser :

Pull out from package ,swift condenser focusing knob

M slightly, lower condenser installing ring to proper

position. Loosing condenser screw, install condenser,

make scale toward front operator position，Then tighten

condenser screw , raising condenser installing ring to the

top.

Electrical Equipment Checking :

Plug power line in power input ⑨, turn on power switch

L, observe brightness of light collector ⑥ , then continue

the next step. Otherwise, please check the process

according to appendix "common malfunction and

troubleshooting".

▲ Please don't touch eyepiece or optical lens during installation, otherwise will effect the

observation.

3.2 Carry

Microscope is a precision instrument,

careful in carry. Shut down power

supply ， pull out power line. Lock the

eyepiece tube and condenser etc, no

slice

left

stage.

nosepiece , focusing knob, mechanical

stage and eyepiece tube etc, don't make

the eyepiece off. Avoid stumble into the

chair, violent shocks and collision can

cause damage.

a. Single hand carry way: with one hand

holding the body, the microscope will

be hold by thumb buttoned filed from

inside.

b. Two hands lift way: one hand turn back the microscope slightly by holding body handle F ,the another

hand holding the microscope's fore piece.

Don't

move

Condenser

screw

Condenser

Installing

ring

Condenser

-４-

common