Bosch WLK24268IN Instrukcja obsługi i instrukcja instalacji - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Bosch WLK24268IN. Bosch WLK24268IN 40 stron.
Również dla Bosch WLK24268IN: Instrukcja obsługi i instrukcja instalacji (40 strony)
Drukuj stronę
Do not use the machine with an
■
extension box, extension cord, spike
busters etc., as this may lead to
improper grounding conditions.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected
~ Page 13
Never use a damaged machine.
■
Inform customer services.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Close the door (do not load any
5.
laundry).
Depending on the model, run the
6.
Drum Clean Û 90 °C or i
Cottons 90 °C program. For AU
variant, two cycles of i Cottons
90 °C programme without laundry
are required to be run at initial setup,
and this operation only needs to be
completed once.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for wool or delicates.
Close the detergent drawer.
10.
Press the A Start/Reload button.
11.
When the program ends, switch off
12.
the appliance.
Your washing machine is now ready to
use.
Positioning and connecting
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Maintenance – filter in the water
supply ~ Page 35
Disconnect the washing machine
3.
from the main plug.
Drain the remaining detergent
4.
solution.
Maintenance – detergent solution
pump blocked ~ Page 33
Remove the hoses.
5.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
The transport locks must be
■
removed. ~ "Removing the
transport locks" on page 15
To prevent unused detergent from
■
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the 0 Spin program.
en
19