Bosch WOT 20352 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Bosch WOT 20352. Bosch WOT 20352 28 stron.
Drukuj stronę
Connections
Electrical connections
Connect the washing machine only to
alternating current via a properly installed
earthed socket.
The mains voltage must correspond to the
voltage specification on the washing
machine (identification plate).
Connection specifications as well as the
required fuses are stipulated on the
appliance identification plate.
Ensure that:
• the mains plug and socket are compatible,
• the cable cross-section is adequate,
• the earthing system has been installed
correctly.
Installation
Safety Instructions
Risk of Injury!
The washing machine is very heavy. Take
care when lifting it.
Frozen hoses may tear or burst. Do not
install the washing machine in an area
where there is a risk of freezing or
outdoors.
Do not lift up on any protruding components.
The washing machine may be damaged.
In addition to the safety information listed here,
the local water and electricity supplier may
have special requirements.
If in doubt, have the appliance connected by
a specialist.
Installation surface
Stability is important so that the washing
machine does not "wander" during spin
cycles.
Surfaces used for installation must be solid
and even.
Soft floor coverings are not recommended,
i.e. carpets or floors with foam
backing.
Changing the mains lead
For reasons of safety, the mains lead is only
to be replaced by Customer Service which
is authorised to do so.
Do not use multiple plugs/sockets or
extension cables.
If a residual current circuit breaker is used,
only use one that has this symbol:
Only this symbol can guarantee compliance
with all applicable regulations.
Do not insert/pull out the mains plug with
wet hands.
Do not pull out the mains plug by tugging the
cable.
Figure 8
Adjustable feet:
(depending upon the model)
Some appliances have two adjustable feet
available at the front with can be used to
correct for surface unevenness. Level and
stabilise the machine in the following
manner:
- Tip the washing machine gently
backwards.
- Depending upon the type of floor, rotate the
foot or feet in or out (Figure 8) .
- Check the washing machine for stability.
9
.