Drawmer MXPRO-30 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt nagrywający Drawmer MXPRO-30. Drawmer MXPRO-30 15 stron. Dual gated compressor

Both channels of the MX30 are identical and may be used completely independently or

linked for stereo operation. In the linked mode, only the left-hand channel controls are

functional and serve as master controls, though the channel bypass switches remain

independent. In linked mode, the compressor / limiters, peak limiters and gates /

expanders of the two channels track together to avoid the inevitable image shifting that

would occur if the two channels of a stereo signal were treated independently.

GATE

Threshold:

Release:

CONTROL DESCRIPTION

This control sets the level below which gating starts to take place

and may be set in the range -70dB to +20dB. The red LED which

signifies signal below threshold, and green LED (signifying signals

above threshold) will indicate the gate activity. Note: because the

gate / expansion ratio varies with signal level, it is possible to

arrive at a situation where the two LEDs may show some action

when little or no perceived gain reduction is taking place.

This means that the gate Threshold may need to be set a little

higher than it would with a conventional gate and final setting is

best done by ear. The adaptive gating system used in the MX30

means, however, that setting up is not over-critical and the gating

action is far more progressive.

Either a fast or slow release time may be selected depending on

the material being processed. Fast release is achieved with the

switch out and Slow release with the switch depressed. Percussive

material with little or no reverb is best treated using the fast

release setting, whereas material with slow decays or a significant

amount of added reverberation will usually respond better to the

longer release setting.

MX30 OPERATORS' MANUAL