Drawmer DS301 Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Drawmer DS301. Drawmer DS301 20 stron. Dual midi expander gate

PARAMETER STORAGE

Unless the new MIDI setting is stored, the DS301 will default to its previously

stored setting when the unit is next powered up. If you wish to permanently store

this data, set both Key Source switches to the MIDI position, then press both MIDI

Prog buttons simultaneously. Data stored in this way is non-volatile and doesn't

rely on any form of battery backup. A bright flash of both LEDs will signify that the

data was written successfully. If the LEDs do not flash, then this signifies that the

new MIDI parameter data matches the data already stored in memory, and a write

was un-necessary.

MIDI APPLICATIONS

The application of MIDI with the DS301 is limited only by imagination. The ability

to generate aftertouch data in addition to basic MIDI notes and velocity opens up

new possibilities for the control of effects units that respond to real-time MIDI

control information. For example, a MIDI controlled flange sweep could be

triggered from an audio event and then timed using the attack setting on the

DS301 set to Gate mode. Conversely, the strength of an effect can be related to

playing dynamics using the Expander mode.

One suggested use would be for replacing an existing tape drum track with a MIDI

controlled sample player, where the existing track would trigger the Gate if a

definite MIDI velocity is required, or trigger the Expander if 'velocity-follows-track'

is required. Ironically in this usage, no audio need pass through the unit at all, as

the DS301 is only acting as an audio to MIDI convertor.

Another use would be to add velocity to an older MIDI device that didn't have

velocity sensing. The Expander would be used to process the audio output from

the MIDI device, and the same MIDI data would need to be sent to both the MIDI

device and the DS301. In this way, with careful setting of the Ratio control the

audio output from the MIDI device would have level adjusted to the current

incoming MIDI velocity data.

-13-