Bosch 800 Series Instrukcja instalacji - Strona 7

Drukuj stronę

WARNING

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply are

shut off before installation or service.

NOTE: This dishwasher is designed to be enclosed on

the top and both sides by standard residential kitchen

cabinetry.

Select a location as close to the sink as possible for easy

access to water supply and drain lines. For proper

dishwasher operation and appearance, ensure that the

enclosure is square and has the dimensions shown in

Figure 1.

NOTE: If your dishwasher opening width measures >18

in (458 mm) use the TOP OR SIDE MOUNT mounting

methods. If your dishwasher opening width measures

7/10

- 18 in (450 - 458 mm) use the ALTERNATE SIDE

MOUNT mount-ing method.

If the dishwasher is to be installed in a corner, make sure

that there is adequate clearance to open the door. See

Figure 2.

Avoid Electrical Shock/Fire Hazard!

Do not allow the electrical and water supply lines to touch.

Enclosure Requirements

Figure 1

Figure 2

WARNING

After locating the proper place for your new dishwasher,

you will need to create any required openings to allow for

passage of the water, drain and electrical line. In order to

avoid interference with the dishwasher when sliding it

into the cabinet, place your openings within the

dimensions shown in Figure 3.

Required Openings:

3/4

3/8

x 2

(120 x 60 mm) - To pass the included

electrical supply junction box through to adjacent cabinet.

NOTE: If the incoming electric supply, water supply and

drain connections are all in the same cabinet, the one

3/4

3/8

x 2

(120 x 60 mm) hole will be large enough for

all three to pass through.

4 x 2 (100 x 50mm) - To pass the included water supply

line toward the water supply.

1/4

(32 mm) diameter - To pass the dishwasher drain

hose toward the drain connection.

Before sliding the dishwasher into the cabinet,

remove the hose clip at the back of the dishwasher

as shown in Figure 4. The hose clip may be used

later to hold the drain hose as shown in Figure 9.

Figure 3

Figure 4