Bosch FAP-OC 500Series Informacje o produkcie - Strona 34

Product Information 500 Series LSN Fire Detectors (EU)

7.2. General Notes for Detector Testing

FAP−OC 500

The

The CO sensor provides improved response behavior and increased stability against

nuisance alarms in critical environmental conditions.

For fire detection, FAP−500 detectors use the time behavior of the fire characteristics,

which differs from the time behavior of disruption variables.

Therefore, for a functional test, the detector must be switched to test mode. Switching

to test mode can occur in two ways, which are described in the alternative test proce-

dures (see below).

Detectors that are programmed for two−detector dependency must be

tested in accordance with the first alternative (in test mode).

For the detector test, you need:

− detector test device for optical fire detector (product ID 4.998.112.071)

− FAA−500−TTL test adapter with magnet (product ID F.01U.508.725).

For OC detector, in addition:

− CO testing gas for detector with CO sensor (product ID 4.998.142.221).

detector has an additional sensor for CO detection in case of fire.

Page 34

PI − 34.70 en

BDL−F.01U.025.876

A5.en/ 02.02.2006

ST−FIR/PRM1 / zab