Bosch HBA43B2.1B Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piekarnik Bosch HBA43B2.1B. Bosch HBA43B2.1B 28 stron. Classixx built-in single multi-function oven brushed steel
Również dla Bosch HBA43B2.1B: Instrukcja obsługi (24 strony)

Bosch HBA43B2.1B Instrukcja obsługi
Raise the top panel and pull it out (Fig. B).
3.
$
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Fitting
Hold the top glass panel firmly by the sides and slide it in
1.
towards the back at an angle. The panel must be inserted

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish does not turn out as well as you had hoped, refer to
the section Tested for you in our cooking studio, where you will
find plenty of cooking tips and notes.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
0
and zeros
flash in the dis-
play.
The oven does
There is dust on
not heat up.
the contacts.
Error messages
If an error message with
"
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
14
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
appears, press the
button. The
0
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
$
Place the cover on the top of the oven door and press in
2.
place. Make sure that the grooves along the sides lock into
position.
Refitting the oven door See the section Refitting the oven
3.
door.
Do not use the oven again until the panels have been
correctly fitted.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.

Glass cover

You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.