Electrolux ELTW20XAKW0 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Electrolux ELTW20XAKW0. Electrolux ELTW20XAKW0 20 stron.

Drukuj stronę

Important

Safety

Instructions

For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to

prevent property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

Recognize

safety symbols, words

and labels

Safety items throughout this manual are labeled with a

WARNING or CAUTION based on the risk type as described:

This symbol alerts you to situations that

may cause serious body harm, death or

property damage.

_This

symbol alerts you to situations that may

cause bodily injury or property damage.

Save these instructions

Read all of the following instructions before

installing and using this appliance:

• Destroy the carton and plastic bags after the dryer is un-

packed. Children might use them for play. Cartons covered

with rugs, bedspreads, or plastic sheets can become airtight

chambers causing suffocation. Place all materials in a gar-

bage container or make materials inaccessible to children.

The electrical service to the washer must conform with local

codes and ordinances and the latest edition of the National

Electrical Code, ANSI/NFPA 70, or in Canada, CSA 22.1

Canadian Electrical Code Part 1.

for future

reference.

To avoid back or other injury, have more than one person

move or lift the washer.

Tools needed

for installation:

3/8" socket and ratchet

Adjustable pliers

Carpenter's level

The instructions in this manual and all other literature in-

cluded with this dryer are not meant to cover every possible

condition and situation that may occur. Good safe practice

and caution MUST be applied when installing, operating

and maintaining any appliance.

Installation

Requirements

Electrical

system

requirements

CIRCUIT - Individual, properly polarized and grounded 15

amp. branch circuit fused with 15 amp. time delay fuse or

circuit breaker.

POWER SUPPLY- 2-wire, with ground, 120 volt single phase,

60 Hz, Alternating Current.

Because of potentially inconsistent voltage capabili-

ties, the use of this washer with power created by gas pow-

ered generators, solar powered generators, wind powered

generators or any other generator other than the local utility

company is not recommended.

OUTLETRECEPTACLE - Properly grounded 3-prong receptacle

to be located so the power supply cord is accessible when

the washer is in an installed position.

Do not, under any circumstances,

Grounding

cut, remove,

or bypass the

type wall

grounding

prong.

receptacle

with 3-prong

grounded plug

Grounding

requirements

- ELECTRICAL SHOCK HAZARD - Improper

connection of the equipment grounding conductor can result

in a risk of electrical shock. Check with a licensed electrician

if you are in doubt as to whether the appliance is properly

grounded.

The washer MUST be grounded. In the event of malfunction

or breakdown, grounding will reduce the risk of electrical

shock by a path of least resistance for electrical current.

Since your washer is equipped with a power supply cord

having an equipment-grounding conductor and a grounding

plug, the plug MUST be plugged into an appropriate,

copper wired receptacle that is properly installed and

grounded in accordance with all local codes and ordinances

or in the absence of local codes, with the National Electrical

Codes, ANSI/NFPA70 (latest edition). If in doubt, call a

licensed electrician. DO NOT cut off or alter the grounding

prong on the power supply cord. In situations where a

two-slot receptacle is present, it is the owner's responsibility

to have a licensed electrician replace it with a properly

grounded three prong grounding type receptacle.

GFI (Ground Fault Interrupter)

receptacle

is not re-

quired.