Electrolux EW 1055 F Instrukcja obsługi - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Electrolux EW 1055 F. Electrolux EW 1055 F 24 stron. Electrolux washing machines

Drukuj stronę

Drain filter

The drain filter collects threads and small objects
inadvertently left in the laundry. Check regularly that
the filter is clean.
Open the filter door by pulling it towards the right.
Place a container under the filter to catch any
spillage.
Release the emergency emptying hose, place it in
the container, and remove its cap by unscrewing it.
When no more water comes out, unscrew the filter
and remove it.
Clean the filter under a running tap, then refit it,
screwing it fully in.
Put the cap back on the emergency emptying hose,
place the latter back in its seat. Close the filter door.

Water inlet filter

If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.
Turn off the water tap. Unscrew the hose from the
tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.

Emergency emptying out

f the machine is unable to drain, proceed as follows
to empty out the machine:
•
Pull out the plug from the power socket.
•
Close the water tap.
•
If necessary, wait until the water has cooled
down.
•
Place a bowl on the floor under the filter and
place the end of the emergency emptying hose
into the bowl. The water should drain by gravity
into the bowl. When the bowl is full, screw the cap
on again. Empty the bowl. Repeat the procedure
until water stops flowing out.
•
Clean the filter if necessary.
•
At the end screw the filter again.

The dangers of freezing

f the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
•
Turn off the water tap.
•
Unscrew the inlet hose.
•
Place the end of the inlet hose and that of the
emergency emptying hose in a bowl placed on
the floor and let the water drain out.
•
Screw the water inlet hose back on and put the
emergency emptying hose back in its place after
having screwed the cap on again.
When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
20