Electrolux EW 1078 F Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Electrolux EW 1078 F. Electrolux EW 1078 F 24 stron.
Również dla Electrolux EW 1078 F: Instrukcja obsługi (26 strony)
Drukuj stronę
11 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme has
finished, the End
pilot light comes on.
Prewash
Main wash
Rinses
Stop with water in the tub
Drain
Spin
Filter
End
The pilot light
flashes to indicate that the drain
filter must be cleaned.
In the event of operating problems one of the
following lights and the END light
= the machine does not fill
= the machine does not empty
= the door has not been closed
To eliminate the problem, see paragraph "Something
not working".
Functions
Pilot lights
Depending on the programme, different functions
can be combined.
When the relevant buttons are pressed, the
corresponding pilot lights come on.
When they are pressed again, the pilot lights go out.
If an incorrect option is selected, the pilot light
flashes for about 2 seconds.
End of programme
When the door locked light has gone out, the door
can be opened. The light
programme progress display illuminates.
Switch the machine off and remove the laundry.
Turn the programme selector dial to O.
Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
Start it by depressing the START/PAUSE button.
Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash.
start to flash:
Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
Opening the door after the programme
has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
The door can be opened when the door locked light
has gone out.
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by depressing the
ON/OFF button
can be opened (pay attention to the water level!). To
restart the programme depress ON/OFF button
again after closing the door.
12
(END) on the
. After about 2 minutes the door