Draytek Vigor 2862ac Skrócona instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Firewall Draytek Vigor 2862ac. Draytek Vigor 2862ac 18 stron. Vdsl2 security firewall
Drukuj stronę
V
i
g
o
r
2
8
6
2
L
a
V
i
g
o
r
2
8
6
2
L
a
LED
ACT (Activity)
WAN2
QoS
LTE
DSL
WCF
USB
2.4G
5G
LED on Connector
Left
LAN P1~P4
LED
P5/WAN2
Right
LED
The port "P5/WAN2" is switchable. It can be used for LAN connection or WAN connection
according to the settings configured in WUI.
c
c
Status
Explanation
Off
The router is powered off.
Blinking
The router is powered on and running normally.
On
Internet connection is ready.
Off
Internet connection is not ready.
Blinking
The data is transmitting.
On
The QoS function is active.
Off
The QoS function is inactive.
On
LTE device is connected and ready for use.
Off
LTE device is not detected, or has serious
problem (e.g., no SIM card, SIM pin error, SIM
deactivated, and etc.).
Blinking
Slowly: LTE device is in dialing up.
Quickly: The data is transmitting.
On
The router is ready to access Internet through DSL
link.
Blinking
Slowly: The DSL connection is ready.
Quickly: The connection is training.
On
The Web Content Filter is active. (It is enabled
from Firewall >> General Setup).
Off
WCF is disabled.
On
USB device is connected and ready for use.
Off
No USB device is connected.
Blinking
The data is transmitting.
Wireless access point is ready
On
Off
Wireless function is disabled.
It will blink slowly while wireless traffic goes
Blinking
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
Blinking
The data is transmitting.
On
The port is connected.
Off
The port is disconnected.
Blinking
The data is transmitting.
On
The port is connected with 1000Mbps.
Off
The port is connected with 10/100Mbps
6